Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Toothed blades

Posts

Re: Toothed blades

#26

OLDTOOLS thread

Wiley Horne

>Paul,

That is a fascinating discussion in OLDTOOLS. Especially when the thread reached the point where your observation of two very old toothing blades in your possession struck a chord with Don McConnell's quotation from a file-making treatise. I was not able to access the graphics which were referenced in that part of the thread, but apparently one of them is what you have reproduced above.

Please clarify: Was the conclusion of the OLDTOOLS thread, that your old toothing blades appeared to have been made by a file-making process? That is, a very hard chisel hammered into the blade back on successive parallel lines, each chisel strike moving metal to create (at once) a valley and a ridge line. If so, it makes one wonder if a toothing blade could be created by grinding a bevel onto a coarse, single-cut file.

Wiley

Re: Toothed blades

#27

Re:Brief great snakes!!!!

tstock

>Guitar manufacturers used to tooth the bottom of bridges for greater adhesion to the top with hot hide glue; however, eventually, someone noticed that more of the toothed bridges come off than smooth, so the practice fell out of favor. Maybe highly stressed joints glued with HHG behave differently.

I have noticed that conventional wisdom on glues gets turned on it's ear when it comes to instrument building.

Re: Toothed blades

#28

Re: OLDTOOLS thread

paul womack

>Please clarify: Was the conclusion of the OLDTOOLS thread, that your old toothing blades appeared to have been made by a file-making process? That is, a very hard chisel hammered into the blade back on successive parallel lines, each chisel strike moving metal to create (at once) a valley and a ridge line.

I have now contacted Don, and happily he still had HIS graphic; here they are, side by side.



BugBear

Re: Toothed blades

#29

Re: OLDTOOLS thread

paul womack

> If so, it makes one wonder if a toothing blade could be created by grinding a bevel onto a coarse, single-cut file.

Yes, I think so, although given the direction of the teeth, you'd need a very wide file, and still have a rather short blade.

BugBear

Re: Toothed blades

#30

Re:Brief great snakes!!!!

Paul M.

>The bridge on my acoustic guitar came off rather explosively, and it did exhibit this toothed marking on the veneer.

It is by no means a quality instrument, and my woodworking skills were much lower back then. But since I cleaned up the old glue and *epoxied* the bridge back on, it hasn't budged since! ;-)