Re: Work surface vs. footprint . . .
Todd O. Cronkhite Maine Native now in Jax Fl.
>Sure will Steve.
T.O.
Knowledge You Can Build On — Est. 1998
Re: Work surface vs. footprint . . .
Todd O. Cronkhite Maine Native now in Jax Fl.
>Sure will Steve.
T.O.
Re: And
Todd O. Cronkhite Maine Native now in Jax Fl.
>Nice little bench Jim, did you build it? I would like to know the tops demensions, and what wood it is made from. I do like that end cap vise as well, looks like it could be very versitile.
T.O.
Ulima
jim reed @ tallahassee
>It is from the original Ulmia company in Germany. My dad acquired it sometime in the 1980's. I will get you some measurements. It is made out of European red beech (I think).
Search
jim reed @ tallahassee
>Do a Yahoo search for ULMIA BENCH. There is a new company that has rights to the Ulmia name and designs.
Re: Work surface vs. footprint . . .
Michael Recchione
>I think it's pretty easy to do the math, at least to first order. The legs are the fulcrum. The weight of the bench acts through the center of mass of the bench, which, if the bench doesn't have anything on it, should be about in the middle of the bench. The top is a lever that is roughly twice as long as the distance from the leg to the center, from the picture. Which means, to just balance on the leg, the force at the far end of the bench can be no more than 1/2 the weight of the bench (I said to first order :-) Any more than that will tip the bench. So, if the bench weighs 300 lbs, anything more than 150 lbs at the edge will tip it. How much do you weigh, Todd? :-)
This all changes depending on what you have on and in the bench, but it's good to get an idea. My opinion is that it's way too dangerous the way it is right now. You probably want to reduce that overhang by half on each end (or make the trestle wider).
New Ulmia
Frank D. in Montreal
>I've bought a few tools (scrub plane and bow saw), and I've seen the bench made by the new ownership of Ulmia, and they are top quality European tools, on par with ECE in my opinion.
Modified Top
Todd O. Cronkhite Maine Native now in Jax Fl.
>This orning I loped off 24" of the top making in now 6' vs. 8'. This seems to have made it much more stable. I clamped the top to the base and was unable to tip it, so I think I may of found a happy mediumn. We'll see.
Now I need to get it attached to the base, than start levelling it.
T.O.
Re: Modified Top
Ernie Miller
>That looks pretty good now so get to palning it flat. do you need my scrub I think it is a #40 It could use a new tote or at least this one refinished so if you could take care of that before sending it back that would be great. I think you should use old plane knobs for pulls on you drawers. and if you have any small drawers you can use knobs off of block planes. if you build a gurstiner use brass knobs off a 60 1/2 or some thing.
Re: Modified Top
Todd O. Cronkhite Maine Native, Presently Away
>Thanks for the offer Ernie, but I've got the scrubs covered, but if you've got a spare #62 kicking around on the back shelves just gathering rust and dust please feel free to send it instead. ;~)
I don't know what I'm going to put under the top, maybe several shallow drawers for chisels, or other small tools, or just leave it open like it is. Ahhhhhhhhhhh decisions, decisions, tho I am leaning pretty heavy towards shallow drawers.
T.O.