Re: A couple clarifications
mikew
>Hi Andrew,
I purchased stock from both MSC and McMaster-Carr. Already hardened and tempered. Tempering can be done in a kitchen oven if it is big enough.
The suggestion by Adam of either leaving the saw non-tapered--and it really has little value insofar as cabinet making--or scraping/samding/polishing the hardened steel is the best solution.
To obtain acceptable results as regards sawing dry woods, little set is required and if anything just a bit of tapering and or rounding on the blade's top edge is all that is required.
If you were making saws for construction materials, or processing less than dry woods, or handsawing funky shapes, then tepering is more an issue.
The latest Kenyon saw I made, the panel saw, is a 26", 8 ppi saw with taper. It was a beast to do--but I think the results are worth it from a historical perspective. Even at that, I didn't fully match the original. Though they probably varied, as did Disstons pre-rolling the taper. Maybe even after then. Point is, the saw cuts extremely well. It doesn't bind even with the comparitively little set it has.
Take care, Mike