Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Made a couple of devils :)

Posts

Re: Made a couple of devils :)

#26

Re: Travisher blades

Skip in Falls Church

>Thanks for the sources Leif! I'll try to whip all these pictures into shape and get an article written soon.

Skip

Re: Made a couple of devils :)

#27

Re: Thanks Skip!

Skip in Falls Church

>Thanks for the source Scott.

I've used them for a total of about 20 or 30 minutes so far. They seem to work fine and were surprisingly comfortable. I do have some advice on itty bitty brass screws though. Always put the last one in first. :) The very last screw of the 12 I used went in just fine - then stuck. I ended up stripping the screw head out then having to drill and dig out the remains. I was so proud of myself up to that point and thought I'd dodge this particular bullet until I tried to take that last screw out. What a pain!

Skip

Re: Made a couple of devils :)

#28

Congrats

ron in Kokomo

>I can think of nothing more satisfying in this craft than getting good results with a tool that you have made yourself.

Way to go

Scot Post made some devils for me and they work GREAT!

Re: Made a couple of devils :)

#29

Re: The secret to brass screws...

William Duffield, on the Cohansey

>...is steel screws. No, really!

Step 1: drill and countersink the hole.

Step 2: pick a steel screw the same size as your brass screw.

Step 3: wax steel screw and screw it in.

Step 4: extract steel screw.

Step 5: wax and install brass screw.

Sometimes, making a rivet from a piece of brass rod works better than a screw, but in this case, there's no place to back it up while you are peining it, and you'd need a really, really small ball pein hammer.

If all else fails, there's epoxy, but that's cheating. And, if you need a photo with shavings to meet a deadline, there's superglue, but that's like taking steroids. You will pay later.

Great shavings, by the way.