PC 890 fixed base router problem

6/25/23, 8:43 PM #1

JL
Member
Offline
6,825 posts

Registered: 7/4/04

PC 890 fixed base router problem

I have a PC 890 series router with a fixed base. � The base in question has the vacuum “port”. � The router slowly slips while I am using it. � I don’t have the problem with the other fixed base (which I use for dovetail work). � Any suggestions?

Re: PC 890 fixed base router problem

6/26/23, 1:56 PM #2

Barry Irby
Member
Offline
13,125 posts

Registered: 1/27/05

Re: PC 890 fixed base router problem

I looked at my PC 890 with fixed base 8901 Type 2. If I open the locking handle fully, there is a hole through the locking handle that lines up with a torx (?) screw. I am guessing if you tighten that screw it will squeeze tighter. I would start with a quarter turn and sneak up on it. Looked it up on E-replacement parts and that screw appears to come coated with LockTite to keep it from vibrating out of position. If yours is not Identical I bet it's similar.

Re: PC 890 fixed base router problem

6/26/23, 4:56 PM #3

JL
Member
Offline
6,825 posts

Registered: 7/4/04

Re: PC 890 fixed base router problem

Thanks

PC 890 fixed base router problem

Posts