Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Old Origina Incra Jig

Posts

Old Origina Incra Jig

#1

Old Origina Incra Jig

Among all the shop cutter at the back, I found an ancient Incra  incremental positioner Then, after looking some more, I found the aluminum fence, square push thing, stop block, and even an extension rod for the stop block. I set it up and plan to fool with it on my router table.

BUT... I can hardly make out the rule markings on the positionern part. The one I have is all the same grey color.

My question is this:  What's the best way to get the rule markings, which are raised a tiny bit, to show off clearly? I'm figuring some kind of dark color. But how to get it just on the raised markings? And If I screw up, how to start over, etc.?


Re: Old Origina Incra Jig

#2

Re: Old Origina Incra Jig

A rubber brayer roller or a piece of rubber glued to a wood block. Use the block like an ink stamp. Dab it on some acrylic paint and dab it on a piece of scrap to remove excess, then stamp it on the markings. Second option is to paint the background black and then a super light sanding or wipe the markings to remove the paint from just the markings.


Re: Old Origina Incra Jig

#3

Re: Old Origina Incra Jig

Sometimes a black sharpie works.  I have a 3D printed sign, rather small, where the raised lettering is just Sharpie ink.  It has been outside for a year or two.  I just re-applied the ink.  Anti junk mail thing.  On the other hand I used it on a daily pill box, and the writing did not last a week.  Whatever you do, try it on a section, and see how that goes, before you commit to messing the whole thing.


 

Those work on a principle, where the scale is adjustable relative to the incra.  So maybe there is some way to even use a numbered tape on it.