Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Frustration With Rail & Stile Bit

Posts

Frustration With Rail & Stile Bit

#1

Frustration With Rail & Stile Bit

Ken Krawford

I'm making some wainscot panels and found a rail & stile bit that's supposed to be for wainscoting. It specifies that it can be used either with the wall as the field or a 1/4" piece of paneling. I'm not going to have an inserted panel.

I've tried every adjustment I can think of but can't get this bit to work.

The bit in the first image is the style bit and the second one cuts the rails.

If you've got any suggestions, I'd be eternally grateful !!

Style-Bit

Rail-bit

Screen-Shot-2021-09-27-at-1-38-39-PM

IMG-2660

Re: Frustration With Rail & Stile Bit

#2

Re: Frustration With Rail & Stile Bit

Garthfromsandiego

Geometry can be confusing. Turn your test pieces around and look at them in the same orientation as the router bit profile picture. The error should then be obvious. You just need to adjust the height of the bits for each cut. Good luck!

Re: Frustration With Rail & Stile Bit

#3

Re: Frustration With Rail & Stile Bit

Steve D, CT

The cutter for the stile is to replicate an ovolo profile, so a 1/4 round with the flats equal. Eyeballing your stile piece it looks like backing off the depth of cut 1/4" to 3/8" will get the ovolo profile. Once you get that you'll need to adjust the stile piece depth to make the faces of the pieces match.

You'll also need to figure out how to get the groove in for the panels. From the looks of things you'll put that groove behind the quarter round by about 1/16 to 1/8 of an inch.

I see lots of test cuts in your future. Once you get a set of pieces that you like in scrap, those will become gauges for setting the cutter locations for your router.