Porter Cable 24: Omni Jig 77240

Re: Porter Cable 24: Omni Jig 77240

Ray Newman

On a whim, I located an on-line copy of the manual. See: http://go.rockler.com/tech/RTD10000496AA.pdf

Not much I could find about bits, but this on page 18 of the above manual:

"NOTE: The bit names (S1, D1, etc.) were developed for use with the OMNIJIG ®. The bit specs for each are on the back of the Dovetail Setup Guide"

Re: Porter Cable 24: Omni Jig 77240

Ray Newman

I could not find any bits specified for the Omnijig on Eagle America/MCLS web site. Maybe a call to Eagle America, Whiteside, etc., for what bits might fit?

Porter Cable still shows the bits in their catalogue, but who knows if they have them?? I would at least look up the specifics for the bit(s) needed and then look on router bits suppliers' on-line catalogues.

https://www.portercable.com/products/power-tools/woodworking-tools/dovetail-and-fastening

Or maybe locate your closest Porter-Cable service center(or other tool service shop??) -- and call:

https://www.portercable.com/support/find-a-service-center

Thanks!

Michael van pelt

Thank you Ray!