Joined The Club

Re: Joined The Club

Virgil Johnson

I see a t slot rail in the rear jaw. I assume you are in the "clamp camp"..:-)

Re: Joined The Club

Derek Cohen (in Perth, Australia)

Mark, looking good! I like that you made all the parts.

Virgil .. "clamp camp" indeed!

Regards from Perth

Derek

Borrowed

Mark Mandell - Gone Round In New Jersey

a few from your posts; thanks Derek!

Had to hunt for the T-track that would take the hold-downs from my drill press table. Hand wheels were smallish to smoothly operate the 1" thread rods so added the crank handles, and put 1x1-1/4 bushings into the operating jaw so it slides easily over the rods.

Re: Joined The Club

Barry Irby

Looking good! The threaded rods look better at your house than at mine. Now I need to copy it.

Your shop's WAAAAAAYYYYY too clean

kneale brownson

Nice job on the Moxon

Da Name of The Place

Mark Mandell - Gone Round In New Jersey

is "I Like It Like That".

Re: Borrowed *LINK*

Keith Newton

Mark, I think I would use cam-clamps in the T if I were doing one. But then I've got a big box of them back in some corner already. They are quick for changing out jig

https://jericoinc.com/product/destaco-horizontal-clamp/


https://jericoinc.com/product/destaco-horizontal-clamp/

Re: Joined The Club

roger lance

Thumbs up......welcome.

Prefer

Mark Mandell - Gone Round In New Jersey

the T-track for 3/8" bolt-heads that I use as hold-downs on my press table. I do use Destacoes on several jigs for both the saws and the router table

Me too

Doesn't Take Much

Mark Mandell - Gone Round In New Jersey

to keep it reasonably clean (No, you can't eat off my floor ), but it's more than hooking the table saw to a dust collector, especially one with a cheap bag.