Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Rub joints

Posts

Rub joints

#1

Rub joints

Bill Tindall, E.Tn.

Rub joints are made by adding glue to a joint and rubbing the parts together until the glue sets up. Rubbing squeezes excess glue from the interface. When most of the glue is squeezed out, the remainder looses water to the wood and the viscosity of the glue film shoots up. The joint becomes immobile to modest pressure. With time the joint cures as the remainder of the water diffuses into the wood.



Rub joints are used to install parts that would be inconvenient to clamp, such as corner blocking in case pieces, as shown on the skirt of this Period Hall Table.

The topic comes up among the hide glue enthusiasts as an advantage of hide glue, implying that other glue will not offer the opportunity to use rub joints. This presumption is not true. White and yellow glue make rub joints that are entirely satisfactory.


As an example I put a drop of glue on the mating surface of these sticks and rubbed them together until the joint seized. I allowed the joint to cure a day and then tried to break it. I could not with just my hands . Eventually I broke it by clamping it in a vise and bashing one piece with a hammer.



Close inspection revealed torn wood fibers all along the glue joint, illustrating a bond as strong as the shear strength of the wood. Good enough.

Re: Rub joints

#2

Re: Rub joints

Thomas Skaggs, Foothills of Mount Level

Good info but truth be told, I prefer Rib Joints. Especially those who use a rub.

T.

Re: Rub joints

#3

O-o-o-o

Mark Mandell - Gone Round In New Jersey

That was dry

Re: Rub joints

#4

Re: O-o-o-o

Hank Knight

A dry rub!

Re: Rub joints

#5

Ellis Walentine

Thanks, Bill

Ellis Walentine

For those not aware, rub joints are indeed a legitimate and time-honored way to install corner blocks and facilitate other hard-to-clamp joining situations. They are less preferable if a tight glueline is important, in which case a clamp would bring the surfaces into arguably tighter contact. Regardless, this is a pro tip that is worth knowing. Thanks.

Ellis

Re: Rub joints

#6

Re: O-o-o-o

Joe shelton

This is a wry twist to a juicy start.

Re: Rub joints

#7

Re: Thanks, Bill

John lucas

I've been doing rub joints for 35 years or more. In woodburning we build entire segmented vessels 2 pieces of wood at.a time. Apply glue, rub the joint until it starts to grab, hold it for 20 seconds and move on to the next 2 pieces. Never had a joint fail. Because of the nature of our segmented cuts you have a fair amount of end grain and the longer holding time seems to help the joint bond.

Re: Rub joints

#8

I miss George Dart


Re: Rub joints

#9

Ellis Walentine

Don't we all