Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Finishing frame and panel assemblies

Posts

Finishing frame and panel assemblies

#1

Finishing frame and panel assemblies

Bill Tindall, E.Tn.

The first frames and panels I ever finished were some 6-panel factory doors for a friend. Sprayed with NGR stain and finished with conversion varnish. That winter there was a "white" border around each shrunken panel. Note to self, pre-stain panels.

There is no perfect way to handle the issue of panel size changes. I am curious how others handle this issue.

I prestain just the raised part of a raised panel. After the whole of whatever this panel goes into is assembled I stain the rest and apply finish. This approach leaves the possibility of a stained but unfinished border showing when the panel shrinks.

Or I stain the whole of the panel and apply the first sealer coat of finish to the panel before assembly. Then assemble the whole of the piece, stain the frame and top coat frame and panel. This approach leaves the possibility of a discontinuity showing in the finish line when the panel shrinks.

Re: Finishing frame and panel assemblies

#2

Re: Finishing frame and panel assemblies

roger lance

I pre-finish everything completely before assembly and use spaceballs to help center panels.

But, I'm mainly working in QSWO and using a simple hand applied arts and crafts finish.

A case in point......


Re: Finishing frame and panel assemblies

#3

Re: Finishing frame and panel assemblies

Barry Irby

I tend to prefinish the panel. Sand, raise the grain, sand, stain and seal. I pay special attention to the end grain in an effort to minimize seasonal movement.

I have wiped stain around the panel.

Re: Finishing frame and panel assemblies

#4

Ellis Walentine

Re: Finishing frame and panel assemblies

Ellis Walentine

Staining the whole panel before assembly makes great sense, as this will kill the color-continuity problem, but spraying your finish coat on the whole assembly works best if the panels are fairly dry compared to their expected expansion/contraction behavior. Dry panels can only expand, driving the finish line into the groove in the frame instead of shrinking away and revealing whatever stain or finish discrepancy that might be lurking.

Ellis

Re: Finishing frame and panel assemblies

#5

Re: Finishing frame and panel assemblies

AZ in Colorado Springs

Stain the panels before assembly. I generally use wiping poly for the finish, and wiping some on the tongues of the panel will also prevent stray drops of glue (such as in the corners) from getting a grip on the panel.

Re: Finishing frame and panel assemblies

#6

Also,

AZ in Colorado Springs

Apply stain to the inner edges of the rails and stiles prior to assembly.

Re: Finishing frame and panel assemblies

#7

like my kitchen cabinets!

Tony - Memphis

They were built in an unconditioned space here in Memphis in the summer. So, yup, almost every panel shrunk and there is an ugly crusty line around them. They did at least stain them all first, so the color is ok. Such a shame too because they are pretty decent cabinets otherwise.

Re: Finishing frame and panel assemblies

#8

As an aside....

Barry Irby

If you build a "picture" frame for a mirror stain and prefinish the inner surface the mirror will rest against. From experience I know that you can see the back side of the groove in the mirror. The same would apply if your panel in your door were a mirror.

Re: Finishing frame and panel assemblies

#9

Re: Finishing frame and panel assemblies

Jim Dillon

I also prefinish any panels, then pin the panels with a 1/8-inch dowel or a cut-off from a bamboo kabob skewer which is a tad smaller in diameter than the dowel. Like Roger, I try to use space balls to minimize vibration - especially on doors.