Re: designing a table
Ray Mtn. Home Ar.
I cheated and just used dowels.
Knowledge You Can Build On — Est. 1998
Re: designing a table
Ray Mtn. Home Ar.
I cheated and just used dowels.
Then it's gotta be this one!
Clint Searl
Re: bull nose...Or Chamfer/Ogee?
another thought...
Barry Irby
You could rotate the column on the base 90 degrees and let it extend down between the pieces of the base. It would change the joinery and might be stronger.
Re: designing a table
Brian Holcombe
Sorry, were you asking for suggestions? If not then I apologize for posting them.
Re: designing a table
Bill Tindall, E.Tn.
I did not understand your 1st reply.
Re: designing a table
Brian Holcombe
I’m suggesting the thickness of the column or post should be maintained, not tapered inward at the connection. Even if it is strong enough it appears weak where one prefers to see strength. I also think the feet could be made considerably more delicate looking by tapering them more abruptly.
Ah, THAT thickness
Bill Tindall, E.Tn.
I think of thickness as pertaining to the thickness of the pieces forming the column. As I understand it you are suggesting to have the column wider at the bottom? That look would be more conventional. I'll draw it up and see......
This would be my choice ....
Derek Cohen (in Perth, Australia)
.. when constructing the colume and top section ...

Regards from Perth
Derek
Re: designing a table
Michael Wilkins
To simulate thickness of an item, try using some foam insulation from your local Lowes or Home Depot. Material cost is minimal and it is easy to work with using a serrated knife and/or rasps.
thanks
Re: designing a table
William Duffield
The "best" tool for cutting foam is an electric carving knife.
Re: designing a table
Yonak
I tend to disagree. I rather find the tapering at the bottom of the column and size of the feet appealing. Everyone has their own sense of style.
A couple examples of
Clint Searl
An Ogee-ish profile that I've used on several table/desk tops.

