Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Pinning tenons with brads - is this common?

Posts

Pinning tenons with brads - is this common?

#1

Pinning tenons with brads - is this common?

Tim Greif - West of Chicago

I'm in the process of refurbing some old bar stools that I bought at Habitat Restore. They are well used stools that had been donated from a Hooters restaurant. Most are pretty wobbly due to loose joints. Some of the joints had been reinforced with steel angle brackets in an effort to extend their life. I figured I'd just knock them apart and re-glue everything.

When I started taking them apart, I discovered that most of the mortise and tenon joints had been pinned with 18ga brads. You can see what I'm talking about in the pictures. This makes things a bit more challenging, but so far, it's working out ok since I can deal with the brads without being a total hassle. These were made in Canada by a company called Holsag Canada.

This got me wondering why you would pin the tenons with brads. Perhaps to give longer life to a chair that's going to get a lot of abuse in a busy restaurant? The hassle is probably worth it since I only paid $12.50 apiece for the stools on sale. I have honestly not heard of this type of joint treatment before. Is this more common than I'm aware of?


Re: Pinning tenons with brads - is this common?

#2

Re: Pinning tenons with brads - is this common?

roger lance

Pinning tenons with brads is commonly done to hold the joint together while the glue dries. If you have limited numbers of clamps and a lot of joints to do; then, pulling a joint together with a clamp.....then pinning the joint....allows you to remove the clamp and go on to assemble another joint.

Re: Pinning tenons with brads - is this common?

#3

New Yankee Workshop Method

Mark Mandell - Gone Round In New Jersey

"Put a nail [ sic "brad"] in it 'till the glue dries."

Quick and dirty construction. Suitable for TV.

Now, if you're using good glue with tight M&T's, forget the pins.

Or, if you want increased joint strength, drill and peg the joint with 1/4" dowels

Or, if you want serious joint strength, use draw pegs on your tenons.

Re: Pinning tenons with brads - is this common?

#4

Re: Pinning tenons with brads - is this common?

Don Stephan

Factory woodworking.

Re: Pinning tenons with brads - is this common?

#5

I'ver seen it often in factory stools


Re: Pinning tenons with brads - is this common?

#6

ebd

Re: Pinning tenons with brads - is this common?

ebd

Where I want more strength I always used/use a blind fox wedge.

Re: Pinning tenons with brads - is this common?

#7

Re: Pinning tenons with brads - is this common?

jesse cloud

I suspect those saying that its a hold-it-together till the glue dries strategy are right. Those brads bend easily and won't provide much strength at all.

Actually, when I am making a jig that needs two parts at a precise angle, I will often secure one with glue and a couple of brads. If the piece is off a skosh, a gentle tap on the brad held piece can bring it into alignment before clamping.