Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Bandini-Done

Posts

Re: Bandini-Done

#26

Re: Lids vs. Drawers

Mark Mandell - Gone Round In New Jersey

Hi Yonak,

Thanks for the comments.

I think given what'll be stored (mostly "outside" shoes) or things like baseball mitts or skates, drawers would tend to get stuck with contents hanging up, plus the lids provide maximum use of the bins' inside dimensions. The piano hinges at the back of the lids sit almost flush with the deck so they won't be sat-apon absent a truly wide load.

;)

Re: Bandini-Done

#27

Re: Lids vs. Drawers

William Duffield

Another consideration, though probably not applicable to a Greene and Greene "ulitmate bungalow," is that this piece of furniture would normally be used in an entry foyer or even a mud room. When full of kids, drawers would substantially impede the disorganized traffic going through the narrow area.

Instead of piano hinges, at least one Greene and Greene cabinet design used rows of tightly spaced butt hinges.

Re: Bandini-Done

#28

Re: Very impressive work Mark!

Larry Clinton At Frankfort, (Central) Indiana

Looks great. Doubt if you allow it to be used like the original though. Many of these were in the Foyer near the home entrance, and were a place to sit and remove wet boots, and winter gear, I always assumed a fastidious housewife would place the wet boots and other items in the storage area to keep the area neat!

Re: Bandini-Done

#29

the platform

ian neuhaus

That is a good looking seat for your son's mud room.

and I agree your arms are better than the original.

did you build the platform your seat is standing especially for this build, if so would you care to share some details.

Re: Bandini-Done

#30

Re: the platform

Mark Mandell - Gone Round In New Jersey

Is actually used when I'm turning. I have a Stubby 1000s that's normally a shade high for my height. When I moved it from the basement shop to the garage I had to put casters on it to be able to move it around (900 lbs.). That raised the spindle height to an unusable level so I made platforms for the front and end of the lathe to give me proper safe working position. A case of "can't raise the bridge, so lower the river" (sort of ;) ) Lathe and platforms get stored in a niche in the garage.

"Plan" was simple: 2x4 frame, 3/4" ply, 2x2's added to the long sides for extra height, and gusseted 2x4's for legs.