Here's a design for you...
Ellis Walentine
Knowledge You Can Build On — Est. 1998
Here's a design for you...
Ellis Walentine
Wow-Thanks for all the responses!
Alan Young
As things have transpired in the last 24 hours it looks like I will be a Track Saw Owner in a short bit. I'll update on the sizing of these boards as things develop here.
-Alan
long straight edge
Steve jenkins
When I was looking for a long straight edge I went to a company that installs commercial windows. They let me look at their scrap of extrusions. And I got a 10' straight one for nothing.
Router
Mark Hennebury
Several people have mentioned using a router which is a pretty good option in many instances and one that you should get used to as it has merit.
I used a router and straight edge for many jobs.
I had a straight edge; A piece of 3/4" of MDF or plywood with a factory edge is fairly straight, and quite good enough , as Bill Tindall pointed out your wood is flexible so the " straight edge" doesn't have to be high precision.
I would not recommend that you cut both edges at the same time as the router is apt to wander off of the fence damaging one of your boards.
1.You need to position the fence so that your router takes a light cut off the piece that the fence is clamped to.
2. the other mating piece should be position just out of the cutting area and be there for supporting the router only on the first cut.
3, you can cut in a direction that pulls the router tight into the fence. (Up- cutting) or if you prefer you can do climb-cutting to prevent tear-out, but you have to make sure that you pull the router tight to the fence and have good control of the router.
4. After you have cut one board (in the up-cut direction)move your router back to the start position and move the second board into the cutting area then make a second pass cutting the second board. The first pass will be up-cutting, forcing your router tight to the fence, your second cut will be climb-cutting also forcing your router tight to the fence.
I used a set of spacers to set the fence to the first board distance and to set the space for setting the second board on the second pass, so it was very quick to set up.
The good thing about using routers and fences is you don't just have to do straight lines, with a good understanding of bits, bearings, rub collars, offset compensation you can do complimentary curves that precisely fit.
