Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

WC Weekend Accomplishments....

Posts

Re: WC Weekend Accomplishments....

#26

Re: Installed a Byrd Shelix head in my planer

Grant Smith

Hi William,

I do think that with jointers there is a need to take a measurement before you disassemble. I am speaking here about the need to ensure the original cutter head is on the same plane vertically with the in feed and out feed table. If not, you may need to shim the bearing surface to ensure the new cutter head is in plane with the tables. Best practice would be to quantify how far the original is off (if at all) from the tables. If it is in plane, then you are in business. Few measure this on a knife equipped jointer, since the knives can be adjusted. Say it is off .003", you might consider shimming the low side of your new cutterhead such that it is raised by the same amount, then take measurements once it is reassembling.

Since the new cutter head has inserts that are not adjustable, you will need to shim the new cutter head to it comes in plane with the tables.

My thinking here assumes both cutter heads are well machined. This is simply an attempt to do an end run around any need to assemble and disassemble multiple times. No warranties expressed nor implied.

FWIW,

Grant in Iowa

Re: WC Weekend Accomplishments....

#27

Re: Installed a Byrd Shelix head in my planer

William Duffield

I appreciate the warning. With a lot of jointers, misalignment of tables is a significant headache. However, mine is a parallelogram design Delta DJ-20, and has microadjustments in all directions on the infeed and outfeed tables, with detailed alignment instructions. So, once I get the new head installed, I should be able to bring the tables into alignment with the head.

http://media.ptg-online.com/media/dm/Articles/FAQs/JointerTableAdjustmentProcedureforJointerswithParrallelogramTables/20040123145450_J05.pdf