Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Order of construction for router table top

Posts

Order of construction for router table top

#1

Order of construction for router table top

Steve Peacock

Hello all, I'm not sure what order I should complete my router table top in. I've glued up 2- 3/4" MDF's. My end product will have 3/4" hardwood edging, router lift, and OU Sooner red laminate on top. Do I cut hole and lip in MDF for router plate first? Or do I cement the laminate and then cut the holes? Should I put the hardwood edge on before the laminate (and therefore on top of edging) or laminate, flush trim and then add hardwood? Thanks for any advice.

Re: Order of construction for router table top

#2

plate last.

Joseph Piotrowski

laminate then trim in solid wood, then make sure you have the mounting accounted for. then cut the plate.

Re: Order of construction for router table top

#3

alos

Joseph Piotrowski

i would trim the entire edge of the glued up mdf.

Re: Order of construction for router table top

#4

Re: Order of construction for router table top

Dick Coers

Put laminate on both faces. If you only do the top, it will warp when the temps and humidity changes. MDF can move quite a bit. I would only put a 1/4" or less of hardwood around the edges, and do that before the lamination. If you add a thick piece of flat sawn hardwood around the edges, it will expand just a tiny bit during those humidity swings as well. Not a big change, but I like a real flat top! The 1/4" is much easier to work flush as well. I'd also suggest an 1/8" chamfer around the edges.

Re: Order of construction for router table top

#5

My  choice

Gary Smyth

It has been a while since I built mine but I glued up MDO substrate first, laminated, cut the dado for the miter path, cut the hole for the router, cleaned it up with a long pattern bit (a big pucker factor as it required heavily relying on double sided tape). Using that hole as a guide and the router plate then used a larger template for the exact dimension of the router plate. After all was done , the edging was screwed on/plugged, the metal miter guide was fit, fence anchor knobs were fit using metal inserts flush with the top and the top of the edge scraped dead level with the laminate. Also by cutting the miter dado first you can use it to align parallel with the router plate. Make sure to give the miter gauge and any fence clearance from the largest router bit you will ever use. The miter slot really ought to be parallel to the router plate. I rounded the table top corners and provided a small bevel to reduce catching sleeves or anything else, which you will be glad you did. I also built the top oversize to clamp stuff (like a light) as that will come in handy more often than you think.


Re: Order of construction for router table top

#6

Again, let Norm be your guide......

roger lance

on YouTube there are a number of videos where router table tops are made including videos from The New Yankee Workshop - Make a Deluxe Router Table.....

Re: Order of construction for router table top

#7

Re: Order of construction for router table top

Joseph Piotrowski

i 2nd laminating both sides as well. the cut-out also make for an excellent push block

Re: Order of construction for router table top

#8

Thanks everyone for all the good advice. NM

Steve Peacock

NM