Drawer backs
Bill Tindall, E.Tn.
A drawer whose back rubs on the sagging divider above it will be an aggravation to own. Hence, finely made drawers are made to avoid this potential problem.
I see from the picture that you fall in the camp of lowering the height of the drawer back. The shop I worked in for a week had two workers. One did as illustrated in your picture. Just make the drawer back less tall. The other made the back the same height and spoke shaved the back slightly concave.
On quartered drawer sides. I wonder if in the beginning English oak sides were simply riven from blocks of oak. Hence, the sides were quartered from the process of preparing the lumber and not from some fundamental requirement for a quartered side.
Truly quartered lumber would be near impossible to obtain where I live. The only commercial lumber available as "quartered" is white oak and it is in fact mostly rift cut. I like the looks of a rift or quartered side but doubt it is necessary to use it. I find true quartered poplar difficult to hand plane and therefore avoid it in sides. I do use rift cut.



