Re: WC Weekend Accomplishments....
John McGaw
Not quite an accomplishment of this weekend, more like last Monday, but I figured I'd throw it in the pot. This is the oversized dining room table I bought the wood for around 15 years ago and put on the rack, afraid to start for fear of messing up good stock with one of my bonehead mistakes. Well, I finally got up the nerve and weathered a bunch of mistakes that had me down to using the very last scrap of stock on hand to finish up. The wood is quartersawn sycamore that came out of a huge tree cut in Pittsburgh and then processed by Talarico out in the east.
Leaving the wood on the rack for so long resulted in some uncontrolled checking which forced me to add a bit of wood to each edge of the bookmatch. Overall it is 7'2" long and 32" wide and probably weighs in at 150-170 pounds. Luckily I had enough forethought to make it to break down into five pieces for easier transport. I had started out planing the top planks by hand since they were too wide for my 12" jointer and planer. That was a fiasco, my skills and tools not being up to the task. Luckily Dan Duncan, a professional furniture maker and member of the local guild was willing to run the pre-made top pieces through his big iron (a 24" helical head planer and 36" belt sander). That earned him three nice bottles of wine from my 'cellar' and made the project possible. The finish is my old standard for sycamore -- tung oil and padded-on garnet shellac for color. Since this is a table and likely to see some wear I added a coat of water-based poly for protection with a coat of Briwax over that.

I will clearly need to make at least a couple of more #5 Shaker straight chairs to go along with it since I only have four of those plus a couple of curved ones from the kitchen table. I'll also have to figure out what to do with the round cherry table that formerly sat in this location.