I have several old chisels I have rehabbed, however I have an old surface grinder in my shop, so regrinding the back flat and restoring the bevel takes very little time. I have one old (I believe it is stamped Buck), that is very handy. I have a set of LN chisels in the leather roll, but tend to use them mostly for paring, I have used a wooden hammer with them a few times but have a cheap set I use for heavy pounding!
The only ones I found completely useless ~ other than opening paint cans ~ were Crapsman. They would chip and the edge roll on the same chisels. Must have been the poorest steel I ever seen.