Re: Poor choice of wording in my first post title.
Grant in Iowa
On these older machines, the machining tolerances are usually closer than today's equipment. I bet it slides nicely. True, one must support the weight of the table, but I bet it would become second nature after a few uses.
What does bug me immensely about a lot of import machines is the lack of a good spindle lock. I often start a hole, lock the bit in the started hole (machine off now) and then use that to set up fences and stuff for both safety and repeatability - I do lots of repetitive parts.
I used a Jet machine at work that the height lock was simply another thumb nut below the depth stop. Really clunky and I hated it.
I purchased the Woodworking drill press from Powermatic right after it came out, on sale for about $1,000. It has the variable speed belt drive. It was made in Asia, and you can certainly tell. It is quite noisy, the fit and finish is not up to the old American made machines.
The chuck is quite poor, the fit of the taper adapter fell out of the machine several times during routine drilling operations. I had to stone off all the high spots, does seem to hold now. However the keyless chuck does not release after doing any serious drilling and requires channelocks to release. I would never purchase that drill again. I would not purchase the one in question if it were Asian made!