Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

table saw for a jointer -third attempt

Posts

Re: table saw for a jointer -third attempt

#26

Re: Huh!

eliot feldman

I think you have me here about the difficulty in registering the router base as more and more of the surface is flattened. So I guess the best I can do, if I want to stubbornly stick to this method, is to rout as much of the board flat as seems practical, and then cut off the rest.

I'm having fun thinking about all this, though.

I don't even know what a P-max is; I assume it's a heavy duty sander type of thing. What do you use it for mostly?

Re: table saw for a jointer -third attempt

#27

Re: P-Max

Mark Mandell - Gone Round In New Jersey

= Performax 22-44 pro drum sander. For stuff that fits, I hog off in the planer then run the stock through the sander to get to spec thickness. It also removes any davits and torn grain from the planer knives. For highly figured wood, the whole job gets done on the sander.

BTW the issue about the router support isn't your only problem. While you could make double-sided washboards, you have no way to index one side to the other on the saw, thus no way to get the sides parallel and the board of uniform thickness. In a planer or drum/wide-belt sander you always have a reference surface (platen or conveyor belt) that is carefully set to be parallel with the knives or the abrasive contact patch. Your saw method may render a wedge in one or both axis.

peace

Re: table saw for a jointer -third attempt

#28

Re: P-Max

eliot feldman

Wait a minute, please.

So let's say I've got a flat washboard on one side. O.K., so now cut off the runners, place the washboard side down on a flat surface, register the (square) runners to the flat surface and the edges of the board, glue on the new runners, and do the other side to sufficient depth. Now it has even thickness. (Granted I don't relish working to get to a specific thickness.)

And , by the way, when you use the router to smooth down the washboard, let's say that things go well up to the last , say, four inches of the board. And let's say the router was set to take off an eighth of an inch. Why can't I use an eighth inch thick hardboard, or whatever, to shim up the part that's smooth and finish the last four inches that way?

I'm beginning to think that there's always a way!

I do enjoy your posts!