Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Freud LU73M012 circular blade

Posts

Re: Freud LU73M012 circular blade

#26

Re: Dewalt 12"

ChuckInND

Mark, nice find on the info. How long did not take you too find it ? Thank you. Before all this I would of never thought about the angle of the teeth on a blade. It just goes to show you that there is always something to learn in woodworking, no matter how long you've been doing it.

Re: Freud LU73M012 circular blade

#27

Re: Dewalt 12"

ChuckInND

I noticed that DeWalt does not say that I can't use the blade, but says that for best results, do not use carbide tipped blades with hook angles in excess of 7 degrees. I'm going to think a bit before I decide if I want to keep the blade, or just resell it. I still haven't heard anything from Freud, and if I do I probably won't hear anything different then I've learned here.

Re: Freud LU73M012 circular blade

#28

5 Minutes


Re: Freud LU73M012 circular blade

#29

Re: Recommendations, a bit of an aside comment

Bruce, a MN Galoot

The only time I pull cut on my slider is with vinyl siding. Push cutting will chip and break the siding, while pull cutting is essentially the same as climb cutting with a router.

Re: Freud LU73M012 circular blade

#30

Re: 5 Minutes

ChuckInND

I looked at the Owners Manual for the DeWalt 12" sliding compound miter saw, and the tooth angle recommendation is the same as with the 12" non-slider. I still haven't heard back from Freud yet.

Re: Freud LU73M012 circular blade

#31

Don't

Mark Mandell - Gone Round In New Jersey

expect Freud to give you anything more than their Legal Department's pre-approved stock answer of:

"Freud manufactures its saw blades to the highest industry standards and publishes detailed specifications for each model as guidance for purchasers. We cannot test our blades on each machine they may fit so it is for the purchaser and the machine manufacturer to determine the appropriate model and specification for their intended use. You should therefore contact the company that made your tool to determine if the product you are asking about is safe and effective when used on the particular tool you have. Thank you for contacting Freud Technical Support."

:D

ps: Dewalt will tell you to "read the manual that came with your saw to determine the various blade types that will fit your saw."

:D :D

Re: Freud LU73M012 circular blade

#32

Re: Don't

ChuckInND

I guess that Freud could of acknowledged my message and sent that to me. I usually do read the Owners Manuals for the machines that I own when I buy them. But this whole blade angle situation I can't remember seeing, I always just went by the tooth count when buying a blade. I'm guessing that there are quite a few folks that don't know any better also. It has been my experience that a lot of folks make the same mistake with Contractors table saws. They just plug them into any 115V outlet in the shop that more then likely has other outlets or lights on that circuit. Then think that the saw is under powered and they need a larger hp saw such as a Cabinet saw. I did the same for the first couple years until I had a electrician educate me, and he installed a couple dedicated circuits for my machines. The saw has been singing without a hiccup ever since. So anyway, a dedicated discussion on tooth angle in the forum to inform others might be a good idea.