Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

dead zone?

Posts

dead zone?

#1

dead zone?

eliot feldman

I watched a video by Mr. Ng on making a table saw sled. It's straightforward and easy to do, and I enjoyed making it. But he confused me about something. He makes the back fence somewhat non-symmetrical and positions the highest point of it off center by about 1 1/2 inches, saying something about avoiding "dead zones". Do you know what he means by this? I did it, too; but I really don't see the advantage.

Re: dead zone?

#2

Re: dead zone?

roger lance

I'm making a guess here:.....a dead zone would be the immediate area around the table saw blade......its an area that you do not want to have your hand.....your fingers......a no-man land.....a dead zone.

My guess is that he located the higher point of the fence in such a way that if you place your hand there, you will not accidentally run into the blade.

Re: dead zone?

#3

Re: dead zone?

eliot feldman

I don't think that's what he meant; he wasn't talking about safety. I should have said that he mentioned measuring things. He was worried about cross-cutting a board, if I remember, to something like 13 inches length. Something a bit non standard. But I didn't get his point.

Re: dead zone?

#4

Re: dead zone?

John in NM

I did a quick bit of googling, and from what I understand the dead zone concept and that question of length have to do with making the sled asymmetrical with respect to the blade. The idea is to have more width on one side so that when cutting somewhat longer pieces you can still clamp stop blocks to the fence for multiple repeat cuts.

Where height comes into it is beyond me though.

Re: dead zone?

#5

Re: dead zone?

Jesse Cloud

I think you've got it John. The high part of the fence is still over the blade for safety reasons and the blade is offset from center for the purpose you mentioned.

Re: dead zone?

#6

Re: dead zone?

eliot feldman

I believe I've got it now. For repeated cuts longer than half the distance from the blade to the edge of the sled, I would use the Biesemeyer off the to right.

But I can see a situation where the required length of cut was just a little bit LESS than the distance from the blade to the, say, right edge of the sled, so there would be no room for a stop block to the right of the work piece, and the Biesemeyer would be of no help. But if the blade is NOT centered on the back fence, and the distance from the blade to the left side of the back fence is greater than what's on the right side, then there would be room to place the stop block to the LEFT of the work piece.

And now I see why Mr. Ng joked about offsetting the center of the back fence by some weird length like 1.454". That must be the width of his stop blocks!