So I bought a Klingspor belt for Performax....
Barry Irby
Called a spoke to them. They explained their conveyor belt for the 16/32 Performax was film backed and very thin but would track nicely. I came the next day. (Nice shipping) The grit on it is white and the film is straw colored. Oddly, the writing on the film is reversed. Matters not but it appears the grit was applied to the wrong side. I installed it and it runs better than the cloth backed belt, but it still tracks toward he motor. So I sand for about an hour and move the belt back. Still fiddling, looking of the magic, but haven't found it. Someone suggested running it a little slack. Tried that, but the film backing is so slick the roller just slips.
The other thing is the film backing is brittle. I have a chip in the edge of the belt about the size of my little fingernail. I also have two small holes near the same edge about 1/8" in diameter. I am not aware of doing anything that should have made the holes or chip. I am skeptical about the life expectancy.
This is my least favorite part of owning tools. I want to use my tools, not work on them. I am pretty sure they own me. I'm still hoping for a suggestion that will stop the drifting belt.



