My Biggest Project Yet! (Long)
Thomas Skaggs, Foothills of Mount Level
All,
I haven't posted in a while, mostly because I have been busy. So busy that I have rarely had time to even log in to my computer. Yesterday I completed the largest project in my career to date. I just completed making all the liturgical furnishings for St. Patrick's Catholic Church, here in Illinois.
If any of you have ever done such work, you know that months are spent submitting designs to committees, and dozens of meetings before you can even start. Then the designs must go to the Bishop for approval. It is quite a process!
This is 6 months of work for me. And if you ever wonder if your shop is small, doing a project like this confirms it! My house became a storage location. I had the tabernacle in my living room, the lectern in my dining room and chairs everywhere!
Last night was the big event. The church just completed a renovation and major addition. Last night was the re-dedication mass. It was huge. The Bishop and about 20 other priests were there to bless the new church and my furnishings. 900 people were there for the celebration.
So here is the altar and tabernacle
The altar is 7' long and 34" wide. It is made of curly cherry and curly maple. I inlaid a bronze symbol that I designed for the church.
About 12' behind the altar is the tabernacle. It is where the communion bread is kept and considered to contain the body of Christ. Most tabernacles are fancy brass boxes that sit on a table. My version is mounted to the wall. It is 5'-6" across! The circular enclosure itself is nearly 2' in diameter. I designed a custom steel mounting system to cantilever it 4" off the wall. I then designed a custom LED ring that is installed on the back side. That is what creates the light halo all around it. The actual enclosure is bronze and picks up on the deign I made.
So the tabernacle is 12' back of the altar. But hopefully you can see the larger relationship as a series of circles. The curve of the half moon in the altar carries thru to the curves of the shelves on both sides of the tabernacle.
Here is the baptismal font
The baptismal font is made with curly cherry and curly maple. It is 36" tall. Again I inlaid the bronze symbol on all 4 sides. I built an LED light under the basin. I designed the basin. It is 30" diameter and made of bronze. Originally it was to be cast glass, but my glass artists tried twice and could not get a successful casting....it was difficult due to the massive size. So we switched to bronze. The basin weighs almost 200 pounds.
Here is the sanctuary
To the left in the picture is the lectern. It was a challenge because I made the top (reading surface) to be adjustable height. I did that by concealing a TV lift system. Then there is also a a bust of wiring things inside like microphone cable and light dimmers for the church.
There are 5 chairs. The largest is called the Presider's Chair. It has a bronze inlay. All are made with curly cherry and curly maple panels.
All the furnishings share some common design elements. I carved a free form design in all of the pieces to provide a textural element
Anyway, for me it was a huge project. But it also became a spiritual journey of a lifetime. Thanks for looking.
T



