Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

My new shop (Pic intensive)

Posts

Re: My new shop (Pic intensive)

#26

One thing to look for...

John in NM

In a compressor is RPM if you want quiet. Some companies make a point of making their compressors as quiet as they can by running large displacement at low RPM. While no where near silent, they can get pretty reasonable that way.

I have a 2 HP (real HP) Rol-air that is pretty pleasantly quiet for a compressor. Hardly have to raise one's voice if at all when running, and I certainly don't reach for earplugs.

Of course, my shop is not in a basement, but the exterior walls are hard plastered rather than drywalled.

Single stage compressors also tend to be less noisy than two stage.

Re: My new shop (Pic intensive)

#27

Re: IR Compressor

Mark Mandell - Gone Round In New Jersey

From a prior thread, I can tell you that Merl's unit is an IR SS3-L3 which is a single stage 3hp unit rated at 10.5 CFM. I've had the same compressor for about 10 years and it's still going strong with the pressure troll set to cycle from 100 to 145 psi. It will not run a Dynabride sander, but is all I have needed for spray finishing, a die grinder, and torque wrenches and lug gun in the garage.

Bought mine from Northern Tools on special for $650 with free shipping direct from IR. Would have liked to have gotten a 2-stage 5hp Quincy putting out 18 CFM, but couldn't justify the more than doubled price.

Re: My new shop (Pic intensive)

#28

Re draining tank

Steve jenkins

It is not necessary to depresurize the tank. When draining a tank is mentioned that is only to drain off any accumulated moisture.

Re: My new shop (Pic intensive)

#29

Re: Is that an IR T-30 Compressor?

mdclor

Stephen, Mark is correct about the model etc. I don't drain the air at the end of the day but I do drain any condensate that may have accumulated. I put a street elbow to a short nipple to a ball valve and another elbow pointing downward so it is easy to drain it. I would guess that it takes about 15 minutes to fill from empty. I almost always use hearing protection in the shop so it doesn't bother me, but I can check the dB tomorrow if you like. My main uses are spray finishing and pneumatic nailing and it is very adequate for those tasks. HTH

Re: My new shop (Pic intensive)

#30

Re: Thanks for all the help

Stephen Roth

I'd like to thank everyone for their help and insights. This has been very helpful. No need to check on the db, I will probably go with some insulated panels for sound deadening ... or maybe put it next to my son's drum set!