Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Anyone have recirulating (instant) hot water

Posts

Re: Anyone have recirulating (instant) hot water

#26

Re: Conservation?

TomD

http://www.amazon.com/Rheem-RTE-13-Electric-Tankless/dp/B003UHUSGQ/ref=sr_1_1?ie=UTF8&qid=1418591829&sr=8-1&keywords=electric+tankless+water+heaters

I was looking at one of these and was surprised at the galactic amounts of power it needed, which I gather is a problem for you, but it might be the lessor evil.

If you ran pex, and insulated it, you might conserve a lot of heat. Copper is hardly the ideal material to conserve heat. Conservation is usually the cheaper option when it comes to heating options. I still run the drinking water through copper but there is pex here and there elsewhere. I love that I can make custom fittings on the lathe to and insert them, even for a day.

On the bacteria in hot water heaters, still, why would you want to run your drinking water through your heating system regardless of whether there is a bacterial problem. I don't even want to drink our tap water if I can avoid it, the product delivered in most regions is "safe" but not water. Running it around in circles through whatever detritus and sludge hardly seems like an uptick.

Re: Anyone have recirulating (instant) hot water

#28

Jesper, Denmark

Re: Yes, but....

Jesper, Denmark

Although there are many houses here older than the USA, they did not have indoor plumbing any earlier than in the USA. Lead piping was never common except for difficult connections, such as from the iron pipe to the toilet.

As an aside, the City of Chicago still required a wiped lead joint from the city supply to the house as late as when I lived in the area in the 1970's. Never understood why?

Re: Anyone have recirulating (instant) hot water

#29

Just like in "Ask this old house"

Neal in San Jose

My new place is a three story townhome with the water heater in the garage. The builder apparently used 3/4 pipe everywhere, and the wait for hot water in the master bath approaches two minutes.

Remembering an episode where they solved a similar problem on "ATOH", I ordered a recirculation pump kit. It consists of a pump/timer assembly, a temperature controlled valve and all fittings and hoses I would need. Per the instructions, I installed the pump/timer between the water heater and the hot water line and the temperature valve under the sink in the master bath. When the timer turns the pump on, it pumps heated water into the hot water line. The temperature valve under the sink allows water to flow back into the cold water line. When warm water shows up, the valve closes and the water stops flowing. The pump is effectively stalled at this point, but in two years there has never been an issue. There is slightly warm water in the cold water line, but not an objectionable amount - when I want water, it is warm I'm looking for and I don't care what the temperature is in the cold side. It' s never been an issue. The entire installation took about 20 minutes, and the kit, IIRC was about $150. Easy, cheap and effective. What more could I want? I later installed a second valve under the sink in the hall bathroom because hot water there was still a bit of a wait.

As far as reliability, I'm not concerned. I installed a three pipe system in my previous home about 20 years ago using the same brand of pump/timer. It actually looks like the same model. My ex is still living there, and believe me, I'd hear about any issues.

The hardest part of this installation was finding a suitable electric outlet near the water heater to plug the pump into. I've been so happy, that I've recommended this to two of my neighbors. The both have installed them and are very happy. One of the neighbors is someone who I put down as sort of a klutz, but he said he had no problem putting it in. Neither has reported any problems to me. I'd do it again in a heartbeat.

HTH Neal

Re: Anyone have recirulating (instant) hot water

#30

Re: Anyone have recirulating (instant) hot water

Jack Prescott

Barry, Install the 3 gallon, 110 volt point of use hot water heaters (available at the big box stores). I did it at the kitchen sink and at the upstairs bathroom and you get instant hot water at the turn of the faucet!! You will be glad that you did! It gives me a warm feeling every time I turn on the water and I wonder why I didn't do it sooner!!??

Re: Anyone have recirulating (instant) hot water

#31

Re: Anyone have recirulating (instant) hot water

Joseph Mulherin, sr

I did some research on the pumps and found two...WATT and TACO. They bpth cost about $200 for the complete kits but do the job.

Re: Anyone have recirulating (instant) hot water

#32

Re: Anyone have recirulating (instant) hot water

DLW

I have had a Recul system installed now for 12yrs, One problem back in 2007, had to replace one of the bypass values, ($44.95) other that that been working just fine. The system back in 2002 cost me $243.00 with 2 bypass valves. My system is a

Grundfos Comfort Series Instant Hot Water System, has timer built into the Pump.

Re: Anyone have recirulating (instant) hot water

#33

Kneale Brownson

Trouble brewing?

Kneale Brownson

We once owned a 45-room motel with "instant" hot water to the rooms via loops in the hot water piping from the boilers that had electric pumps in each loop. As this system aged, what we were told was an electrolysis process was eating through the copper piping. I spent a lot of time soldering in new sections of copper over the years.

Re: Anyone have recirulating (instant) hot water

#34

Another bad thing about per,

Keith Newton

My last helper and his landlord ran pex in a couple of older homes they were restoring. A rat chewed through it in the first year, so unless you have a rat-proof basement, or crawl space, just keep in mind that it probably looks like a long candy bar to a rodent. ha