Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Geometrical confusion: laying out a cut

Posts

Geometrical confusion: laying out a cut

#1

Geometrical confusion: laying out a cut

Bill Houghton, Sebastopol, CA

I'm putting outside casing on a window installation on our Olde Haus. I'll be applying it on top of a slanted sill, but the casing also has to go at an angle vertically; in other words, the cut, seen from the face, will not be 90 degrees, but off by about five degrees, in addition to the slant of the cut seen from the edge. Work is being done on a chopsaw.

I took off the angles with adjustable bevels. Can I tilt the saw, using the bevel setting for the sill tilt; and then adjust the tilted saw to the angle for the face cut? Or will the first tilt throw off the second one?

Re: Geometrical confusion: laying out a cut

#2

Re: Geometrical confusion: laying out a cut

roger lance

Bill.....why not just make some practice cuts with scrap ??

Re: Geometrical confusion: laying out a cut

#3

Re: Geometrical confusion: laying out a cut

John in NM

I'm sure there's some way to do it with a compound saw, but I've never been patient enough to simply read the instructions :D

What I do instead is shim up the piece of molding to get that 5 degrees and then make the miter cut as measured. Should come out as well as your measurements, but do cut a few practice pieces first :D

Re: Geometrical confusion: laying out a cut

#4

Re: Geometrical confusion: laying out a cut

don stephan

A third option is to make the tilted cut as needed, then back bevel the bottom with a block plane and/or a rasp. Finally, mark the top of the casing and cut.