Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Got a tricycle and need

Posts

Got a tricycle and need

#1

Got a tricycle and need

Larry in NW Ohio

a part that holds the front wheel to the fork. Would anyone know where I could get any on the cheap and I`ll gladly pay postage, also would anyone know what they are called. Also would like to have metal if they still make them.TIA Larry

Re: Got a tricycle and need

#2

Trick Question?

Mark Mandell - Gone Round In New Jersey

Larry,

I hope you're writing about a little kid's trike and that you're looking for something other than an "axle" which you could make with a 3/8" bolt.

;)

Re: Got a tricycle and need

#3

Re: Trick Question?

Larry in NW Ohio

Yes Mark I am talking a little trik, the front wheel is only about 10", and the part is the one that holds the wheel onto the front fork. Thank you Larry

Re: Got a tricycle and need

#4

Trike

Mark Mandell - Gone Round In New Jersey

Larry,

Most any bike shop should have or be able to source a replacement front axle for your piece depending on how the the pedals are set up. If, however, the pedals are set up as 1-piece pedal/wheel assembly on the front fork, it may be hard to find, and you'd be better off just buying a new trike.

Re: Got a tricycle and need

#5

Re: Trick Question?

Bill Houghton, Sebastopol, CA

I've seen kid tricycles that have a kind of clip that bolts to the front fork and carries the axle. Not as simple as a bolt.

Re: Got a tricycle and need

#6

Re: Got a tricycle and need

TomD

To be more specific. Are you taking about the drop, which is the part that the wheel assembly attaches to on the fork. Or are you taking about the anxle, or skewer using which clamps the wheel to the fork. Or some safety stuff that is a new add.

Normally the axles on cheap stuff are solid, the ends are threaded, and nuts hold the wheel assembly to the drops. Drops are widely available, but they are often just flattened tube segments also. Replacing drops normally requires welding, or brazing. You can use 1020 to fab drops.

Re: Got a tricycle and need

#7

Re: Got a tricycle and need

Larry in NW Ohio

I am talking about the part that bolts to the fork and the axle of the wheel goes thru. It has a hole on the bottom of it the size of the axle for axle to go in and there are one on each fork. Larry

Re: Got a tricycle and need

#8

Oh, THAT Part . .

Mark Mandell - Gone Round In New Jersey

Is called a bearing holder and is actually a 2-part assembly of holder and bearing that slips over each pedal/axle arms and then bolts to the ends of the fork. From what I could see, each one is made to fit the model trike. If that's correct, you would have to contact the manufacturer or find the same or similar trike to use as parts.

Absent that search, take it into a bike shop to see if they can faghazy replacements.