Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Cock beading a curved edge

Posts

Cock beading a curved edge

#1

Cock beading a curved edge

Bill Tindall, E.Tn.

Cock beading a curved edge

When I made the bow front chest of drawers I cock beaded the drawer edges. The procedure could be the same for the curved apron of a table. The following procedure is what I learned in the Mack Headley and Sons shop in Winchester, VA. (Have I mentioned that I learned a lot in this class?)

PIC 1


PIC2


The “reveal” is defined as the amount the cock bead sticks out from the face of what it is cock beading, in the case a drawer. A small piece of wood whose thickness equals this reveal is prepared as a gauge block. To begin I temporarily braded the 1/8” thick strip of cock bead material to the drawer edge. Then using this gauge block the reveal line was marked on the cock beading strip using a fine black gel pen.

PIC 3





The strip was removed and roughly band sawed close to the reveal line. The edge was then planed down to the reveal line. It could be spoke shaved but I found planing easier. I also found it easy to temporarily reinstall the strip on the drawer for planing and while planing I could check the reveal by eye. .

PIC 4



The cock bead scraper was made by cutting a semicircle into a piece of scraper stock with a chain saw file. It is essential that the cutting face of the scraper stock be polished or the cutting edge will not be sharp. I found it easier to pull the limber strip past the fixed scraper rather than the more customary pulling the scraper across fixed stock. There is no need to get this profile perfect. In fact there is something to be said for not getting it perfectly semicircular, everywhere.

PIC 5



The cock beading is installed with brads and glue.

Re: Cock beading a curved edge

#2

Re: Cock beading a curved edge

Larry in NW Ohio

Bill You sure do have a way of making rough lumber look great after doing a little plaining and sawing. Great job. Larry

Re: Cock beading a curved edge

#3

Re: Cock beading a curved edge

Joe in a Cleveland suburb

Bill,

Thanks for taking the time to share this info with us.

I REALLY like the color of the finished Walnut.

You said in a post on 5/28/13:

"I use the following: Japan Color "burnt umber" and mix it 10% with General finishes "pre-stain wood conditioner" "natural". This is basically the formula used by General Finishes for their oil stains according to a reliable source. The mineral pigments don't fade. "

Is that the procedure you did with this dresser?

Thanks.

Re: Cock beading a curved edge

#4

The short answer is yes. more accurate PIC

Bill Tindall, E.Tn.


The color in this picture is more accurate. It may be slightly redder than what it shows in natural light. Those previously posted were a bit on the yellow side.

Re: Cock beading a curved edge

#5

Re: The short answer is yes. more accurate PIC

TomD

I'm not a carved details guy, particularly on a clean design like that, but wow! That is excellent work! A really superb piece.