Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Half round table. Testing my form.

Posts

Re: Half round table. Testing my form.

#26

Re: Half round table.  Testing my form.

Jesse Cloud

Wow - what a thread! Sure are lots of ways to skining a cat! And they all work!

Having said that, I can't resist throwing in my two cents worth:

The coments about using bigger caul blocks and/or masonite strips are spot on. You can get by with less on hardwood boards, but veneer can creep and bow up between pressure points. I usually add about half an inch of extra plies to use as cauls. Also, this is where vacuum bags shine - they deliver equal pressure all across the piece.

Lots of different glues will work just fine. You can put it on with a spreader or a brush or a roller. I've tried them all, and I'm partial to rollers, but use what feels right to you.

You don't need a lot of glue, but it does need to be applied evenly and cover the whole piece. And you do need to put glue on both faces that you are joining.

Too much glue will make a lot of squeeze-out and make the clean up of your board all that much more work.

Try hard to keep the stack straight, if it shifts around, its gonna be hard to clean up.

The bane of laminations is getting glue where you don't want it - easy to do if you get rushed. I like to pencil in "no glue" on the face that will be next to the form and on the face that will show.

And, as said above, THE DRY RUN IS YOUR FRIEND!

Once you master the technique of bent lams, I'll bet you find lots of uses for them.

Good luck and keep those pics coming!

Re: Half round table. Testing my form.

#27

may I repeat.....

Bill Tindall, E.Tn.

...how easy it is in the rush of assembly to put glue where no glue should be?

" I like to pencil in "no glue" on the face that will be next to the form and on the face that will show."

Re: Half round table. Testing my form.

#29

Beautiful!

Tony - Memphis

Nice stairs!

Re: Half round table. Testing my form.

#30

And....may I repeat.....

Barry Irby

"Lots of different glues will work just fine. You can put it on with a spreader or a brush or a roller. I've tried them all, and I'm partial to rollers, but use what feels right to you.

You don't need a lot of glue, but it does need to be applied evenly and cover the whole piece. And you do need to put glue on both faces that you are joining."

I have been meaning to mention wetting both faces in each lamination. In your case I think you want to just barely wet one face and put slightly more on the mating face. I would try the foam roller or a very short hair roller. I would have a notched card handy for any excess. Put the stack in front of you like a deck of cards. Flip the first one away form you and wet the inner face and then the one on top of the stack get the very light coat. Flip it on top of the first one and go again. Just be sure not to glue the outer face of the last one. By re-stacking them as you go you tend to keep the glue wet longer. I use chalk to mark the inner and outer face boldly to prevent gluing them in the heat of the moment.

Re: Half round table. Testing my form.

#31

Re: And....may I repeat.....

Joe in a Cleveland suburb

Both faces. Got it. Thanks you and all for the replies and help.

I hope to do this this weekend!

Re: Half round table. Testing my form.

#32

Re: And....may I repeat.....

Barry Irby

Good luck, I think you will do well. This has been a wonderful thread with lots of varied advice and you should have no trouble picking a path that will work for you.