Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

jointer question

Posts

Re: jointer question

#26

Re: You are both right...

Tom

Depends on how you run the wood over, and the set-up is low on the outfeed, not drooping.

Re: jointer question

#27

I was thinking that too...

John in NM

But I don't have a lot of experience to draw on....

Never had the snipe that I recall, I can only speculate that it occurs when the outfeed bed is very low.

I do get the belly or taper cut now and then, always goes away when I raise the outfeed bed ever so slightly.

A lot does seem to depend on where pressure is applied in the cut.

Re: jointer question

#28

Ellis Walentine

Ah, but, a corollary

Ellis Walentine

Jointers are actually very basic machines, and you can adjust everything but table flatness. I would say don't buy a jointer that has tables that are twisted or out of flat. Other than that, everything else is adjustable. gib shims, knife height, even bearing blocks in most cases.

Ellis

Re: jointer question

#29

Re: jointer question

William Duffield

Thanks for that excellent explanation, Bill. It never occurred to me that the bushings would be eccentric, but now that you've explained how they allow the jointer to be tuned, it makes perfect sense. I'm going to print out your procedure and put it with the rest of my jointer documentation.

Re: jointer question

#30

Re: I was thinking that too...

Tom

I thought snipe was mostly a planer thing. I try to work things to where it won't be messing up a joint and then deal with it in the final finishing or when trimming boards. I haven't really gone into eliminating snipe as many do. As a hand tool guy I am never going to be satisfied with what comes off the planer. Seemed like there was like 2 decades around here when every piece of commercial woodwork was red oak, finished with the ripples off the planer or shaper on proud display.

Re: jointer question

#31

Re: Ah, but, a corollary

Tom

That is true, but there is stuff you want to adjust, and stuff you shouldn't have to. I'm fine with adjustable outfeeds, I have used jointers that didn't have them. But shimming gibs, that would have to come witha big discount. :)

Re: jointer question

#32

Re: Nomenclature?

Tom

I don't think it is worth the trouble changing people's ideas on nomenclature, even if it were possible. Anyone else think, though, that the English terms of planer and thicknesser, are better than Jointer and planer. The jointer is a fixed, large, powered wood "plane". It is not just for joints. The planer is not like a wood plane, it basically sets thickness.