Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Samantha's dresser Part 2 Design and "plans"

Posts

Samantha's dresser Part 2 Design and "plans"

#1

Samantha's dresser Part 2 Design and "plans"

Bill Tindall, E.Tn.


This discussion should have been part 1...but I am disorganized.

Part 2 Design

The dresser is a ¾ sized affair “designed” to be approximately 48” high and 28” wide and about 17” deep. . None of these dimensions are critical at this point. In fact, the lumber for the sides worked out better to make it 18” deep and just a bit taller to capture some nice grain at the bottom and enable the edge joints to mate more attractive while keeping the pattern centered. The bottom line of it is to not be wedded to some exact size from a plan.

When I examined antiques I saw that dovetailed drawer runners did not pull away from the case sides over time, while mortise and tenon usually did. The dresser will incorporate a false top dovetailed into the sides. Its function is to provide “kickers” for the top drawers, hold the case sides together and flat, and provide a place to screw through to hold the top on. The drawer dividers will be dovetailed into the case sides. Often the back dividers were mortised and tenoned to save labor over dovetailing. However, I find the dovetails so easy to do I do them everywhere.

It would be best to install a solid bottom dovetailed into the case sides with sliding dovetails to help constrain the sides to remain flat. This feature is especially important if the orientation of the grain in the sides could cause them to seasonally cup inward, which would bind tight fitting drawers (had that happen once and it was difficult to hand plane the inside of the assembled case back flat.). Its main function is to keep the sides from cupping inward and narrowing the drawer opening. It does not have to be a precision fit to accomplish this task. I am not going to bother with this feature on this piece.

I do not use dust panels. I regard them useless and they add weight.

I am not fond of the feet I have sketched. Maybe inspiration will follow later.

Re: Samantha's dresser Part 2 Design and "plans"

#2

Re: Samantha's dresser Part 2 Design and "plans"

roger lance

If you keep that 48" height.....and the width were 30"......you'd be very close to the golden mean.....even 28" is close.....see, you do sometimes design like the holy principles of woodworking advise.....despite yourself. :D

Re: Samantha's dresser Part 2 Design and "plans"

#3

Re: Samantha's dresser Part 2 Design and "plans"

John Pappas

I am not fond of the feet I have sketched. Maybe inspiration will follow later.

Perhaps: add a little height to the base and bottom rail, add a gentle curve to the bottom rail, curve the feet gradually to a smaller footprint.

Re: Samantha's dresser Part 2 Design and "plans"

#4

Re: Samantha's dresser Part 2 Design and "plans"

Bill Tindall, E.Tn.

"curve the feet gradually to a smaller footprint."

I was wondering whether they didn't look good because they were too fat. I'll draw some more. thanks

My design skills suck but oddly I can tell if I stumble into, or someone shows me, something good.