Pantry project done
Mike Foster
Quite a while back I asked folks here about some construction dilemmas I had for a set of pantry shelving I was designing. I got a lot of useful suggestions and used a couple of them. This pantry highlights wood from a couple sugar maple trees that went down in our woods about 5 or 6 years ago. I hauled the trees out had a friend mill the wood, which then was stacked and left to air dry in my fields for several years. Cool thing is that these were trees I had tapped for maple sugar and some of the wood has those tap holes and the resulting streaking caused by bacterial invasion similar to ambrosia maple. It is a prized wood here in VT and is dubbed tap-wood.
The dilemma in design came from a couple of features my wife wanted. She did not want any side supports and wanted the shelving to be as open as possible. Supporting that weight was the issue. My solution, with help from the great folks here, is that the wood for The shelving is a full 4/4 surfaced rock maple, each shelf is supported by cleats and screwed into the cleats and I added some support from the beams on the front end of the units. The L shaped unit was a bit of a dilemma regarding wood movement. Someone here suggested breadboard joints, but I decided to go a step further and used sliding dovetail joints. This allowed an open shelf in the corner, which is really nice. The cabinet near the post and the shelf unit above it are designed to be removed if we ever get too old to go downstairs and do the laundry. We could easily install a washer/dryer combo here if needed. The cabinet just to the right has a large pull out bin that will store our dog food.
All doors are mortise and tenon pinned with ebony. There is a mistake highlighted by the ebony pins that you might be able to pick out if you look.
So this was my Xmas present to my wife and an 11 year project finally made good. Thanks to all here who gave me some great ideas.




