New Island for the Cabin, Frogwarts. *LINK*
Keith Newton
Over the weekend, I got the Island down and installed, with a final coat of finish on it. This takes care of my Christmas gifts for me. Of course, I guess I will benefit from having it more than any of the others, since I spend more time there than my sister, and her son and his family.
The wood is from one of the oldest homes in our hometown, formerly owned by Mrs Sally Lou Wilson, who started and ran the county library. That home is now owned by one of my sisters classmates from grades 1 - 12, graduating in 54. They offered the tree to me, so I cut it on my Woodmizer LT 15.
Not that it would have been too bad in this rustic environment, but Eastern Red-cedar is pretty soft for a counter top, and since I had some thin penetrating epoxy on hand, I saturated. Before mixing and warming the epoxy, I put the top in a hot-box, and warmed it up good for a couple of hours before brushing it on. As the warm expanded air within the cells cooled, it would contract and pull the epoxy in deeper than just coating it in my cool shop. I then put it back in the box, and turned the heat back on. I'm really pleased with the results, it feels as tough as plastic laminate, without looking like it. I think I may have just invented Faux Cocobolo. Say that fast 3 times, it has a nice ring to it. I hope it keeps the gold, pink and purple hues, but I'll be surprised if it does.
You can see virtually the whole L shaped kitchen in the first pic, except the fridge it just out of it on the right. The kitchen sits in the corner of a great room about 16' x 30'. We really needed more counter top space.
Thirteen of our family members gathered there for Thanksgiving, so Sister Gail ask if I could come up with an island. Since my job-site workbench was under the cabin next door, I brought it over. It is this size, except with more overhang on one end to accommodate a Wilton vice. Once I set it up, it was pronounced to be perfect, and that it would have to stay. To which I answered BS.
The top measures 2.25"x 32"x48", made with two book-matched boards, held straight with two maple T rails, which double to screw drawer slides onto, and to fasten the top to the legs. The wood can expand and contract along the waxed T arms.
I have some nice beige waxed thread/string which will replace the black nylon securing the antler tip of the drawer pull. And I'll try to find a good color power strip to fasten onto the inside of a leg just under that drawer. And that cord end coming up through the floor will be replaced with an in-floor receptacle more back under the center out of sight.
The old work bench that I mentioned above doesn't have any drawers like this. I made it over 30 years ago to go out to job sites to catch the out feed from a little 9" Rockwell contractor saw. I tried to keep it small to keep it portable, but large enough to catch full sheets of plywood, which it has done thousands of times. I wish I had thought to provide for drawers back then, but I didn't stagger the cross rails like this one, but I could go back and add the drawer up under the top, and will when I bring it back to the shop.
For anyone working in a small shop or garage needing a bench to easily pull out, and then put away, I take a good look at this. On my little bench, I have wheel coming off the side of the bottom of the legs on the long overhang/vice end, which make it easy to drive around, when I lift the other, then get near the center of gravity over the wheels.
The combined area of the 3 drawers is 8 sq ft. 4" deep, but those could be made deeper, and could hold a lot of tools.
http://www.flickr.com/photos/7391658@N03/11409063365/in/set-72157638744137324



