Outstanding
Bill Tindall, E.Tn.
Seems obvious now to just soak kitchen stuff but I hadn't thought of it.
Knowledge You Can Build On — Est. 1998
Outstanding
Bill Tindall, E.Tn.
Seems obvious now to just soak kitchen stuff but I hadn't thought of it.
you may be thinking of.....
Bill Tindall, E.Tn.
.....an article by Flexner where he said that any oil based finish, for example varnish, was equivalent.
Re: BLO and grain popping
Clint Searl
"This is because light actually goes a bit deeper before being reflected because we have made the very top of the surface more translucent and less opaque. Naturally, this can be done with either clear or colored materials."
Ignoring oil's yellowing effect in emphasizing grain, it would seem that the wood's reflectivity is more enhanced by a water white resin rather than a naturally flat sheen oil, which may have a muddying effect. Moreover, clear resin will best highlight the wood's chroma.
Correct. The trade off is...
Michael Dresdner
That is absolutely correct.
Going with oil, because of its color, is definitely a trade off to the true color of the wood and the maximum depth appearance you can get with a clear resin.
The problem, of course, is finding a clear resin that has a low enough molecular weight to impregnate, and still stays clear on curing. The one we use most (when we do not want to add any color) is polyester. Prior to curing, the monomer that creates polyester is both small and motile. In some cases -- I've seen it happen often on thin woods, like guitar tops -- if the monomer is not cured quickly enough, it bleeds all the way through the wood to the other side.
However, as you point out, if you want depth with no color added, that is one very effective way to go.