Not even half-fast, over 30 years start to finish. *LINK*
Keith Newton
I was out working in the cold wind and drizzle today, rushing to finish up a job I started over thirty years ago. It is a little porch on a Victorian house about five blocks up the street from my shop. The owners have a big party planned this weekend, so I had to do a rush job to get it finished. ha
There is a big high-rise condo across the street, that sits 45º to the world, which causes a bottle-neck wind situation. This more than doubles the windspeed, if today's weather wasn't bad enough. Looking at a weather map today, most of the Northern half of the state of AR is getting snow or ice, but here it is still above freezing here, yet dropping. Tomorrow we probably will get a freezing rain, maybe 1" of ice, with lots of trees breaking and power outages.
A bit over a year ago, I was walking Sassafras the pup up the street, while the Sargents were getting groceries in from the car. I called over, "Like your house, especially that porch". They looked at me funny, then I told them I had built it ~30 years ago. They called me over to meet and talk.
Since then, they managed to buy and strip about half the balusters and spandrels, and some brackets from another victorian house which got demolished here in town. Ed is an Architect, and performed the task of stripping of the old parts. Willie Simmons, another WC member over on the turning forum answered my summons for someone to turn about 30 each of balusters and spandrels, so about half is new to match the old.
The rest of the parts, I made here in the shop. I turned the newels, finials, and little spindles in the corners of the big arches. I milled all the rails. Everything was pre-painted, even on the inside where parts are joined, and it was all assembled with screws in a manner which will allow everything to be disassembled, in the years ahead.
Oh yes, even the ends of all the rails were sealed before final assembly. You may remember that a few weeks ago I ask fort suggestions for a lube to help get the tight parts together. Y'all would have been proud of me today. One little short section was left, because we came up short 2 balusters. So they got finished along with the small brackets under the spandrel rail. When I tried to get it together, it jambed way too soon. I didn't have any my gear from earlier, other than drill and screw-gun so being cold miserable, not wanting to stop to run back to the shop, I used SPIT to lubricate it. Ha, It worked great, and I'll have to admit, I've used it for other lubricant task before, but we won't go there. he he
http://www.flickr.com/photos/7391658@N03/sets/72157638394450783/
, but it looks a lot better than I could ever do. Larry


