Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

"crowd editing" cutting board finishes

Posts

Re: "crowd editing" cutting board finishes

#26

Re: Varnishes and oils

William Duffield, on the Cohansey

"In the pores a rubbery material would seem to be as effective as a hard one."

If that were true, then Dave Jeske's Blue Spruce Toolworks mallets, which are infused with acrylic resin, wouldn't perform any better than a wooden mallet finished with BLO. All reviews I've seen indicate they are much more durable than any other wooden mallet.

http://www.bluesprucetoolworks.com/#!mallets/c1ecw

Re: "crowd editing" cutting board finishes

#27

I prefer rubber

Bill Tindall, E.Tn.

No matter what it is infused with, wood pounding wood still produces what I find to be an annoying sound. Were it not for tradition I suspect the idea mallet would be urethane.

Re: "crowd editing" cutting board finishes

#28

Re: …or hearing protection

William Duffield, on the Cohansey

Choice of mallet is, I think, a very personal thing, with lots of different parameters affecting its performance. I think some of my permantne thearing damage is due to a wooden mallet striking a wooden carcase during a glue-up. Also, I've had furniture surfaces damaged due to wooden mallet blows.

While mallet durability at the extreme end of the scale may give some indication of cutting board durability, and lend support for Ellis's hunch, whether there is a significant practical difference would be a lot more difficult to determine, and would probably not be worth the effort of the testing, especially considering all the variables. My recommendation would be use what you have, be it a semi-hardening vege-oil, BLO, Watco, Waterlox, Salad Bowl Finish, or even a Poly wiping varnish. If it has a petroleum distilate carrier, make sure all odor of the carrier is gone before you use the cutting board. Hopefully, all of our noses are trained well enough to tell the difference between mineral spirits (even the "odorless" variety), naptha, and turpentene on one hand and triglycerides, EVOO, etc., on the other.

Re: "crowd editing" cutting board finishes

#29

thank you for the data

Bill Tindall, E.Tn.

Some years ago while advocating vegie oil for cutting boards I made the claim that it would cure/dry similar to linseed, if given enough time. M. Dresdner (spelling?)disputed this claim. Delighted to have data to prove my claim.

There is good chemical reason to suspect that eventually soy should make a solid film because is has some (but not as much) of the triglyceride that enables linseed oil to relatively quickly react with oxygen to make a coating. (This triglyceride has more carbon atoms deficient in hydrogen that will react with oxygen to set off the chain of events that results in a tough film. In chemistry, more usually means faster, maybe a lot faster)