Halfway Measures
Mark Mandell - Gone Round In New Jersey
So Bill,
I've seen photos from Tennessee where multi-tone paint jobs on cars seem to be all the rage, along with outdoor home appliances. Seems like a bit of overspray would fit right in. No?
Knowledge You Can Build On — Est. 1998
Halfway Measures
Mark Mandell - Gone Round In New Jersey
So Bill,
I've seen photos from Tennessee where multi-tone paint jobs on cars seem to be all the rage, along with outdoor home appliances. Seems like a bit of overspray would fit right in. No?
Re: One more important consideration
Larry Clinton At Frankfort, (Central) Indiana
I normally spray in my driveway, moving my vehicles beyond the point of overspray, (watching the wind direction). I have sprayed in my shop garage door opening in the winter (overspray goes into driveway) without too much problem in the shop. I have found that normally the overspray from my "thinned" finish, is "dry" in about 10' in the summer time and doesn't stick to surfaces (like my house siding or vehicles). Winter is a different situation, so I keep everything away from the spray area and don't spray if there is any wind.
Re: Halfway Measures
Bill Tindall, E.Tn.
I find it more durable than any wax product available
It locally known as "TN Clear Coat". Just keep it off the windshield.
I washed and waxed a car once but didn't find the time well spent
Re: I would not go there
Joe in a Cleveland suburb
IF I get into spraying, it will have to be outside for sure.
I will also get a quality mask.
Re: Go Half Way
Joe in a Cleveland suburb
Not so worried about her car. I don't want any overspray om my M3...
Using the garage isn't much of an option either. It's a dark scary place full of big spiders. 
Re: One more important consideration
Joe in a Cleveland suburb
Spraying in my driveway is a bit of a concern. I live in the city and the houses are about 10 feet apart.
I envision a cloud of spray all around me drifting towards the neighbors. Maybe the over spray isn't that bad?
If/when I get a gun and play around with it, it won't be until Spring at this point because of the temps (it's snowing right now, uhg). I'll play around with water to see what happens.
Thanks again for all the replies.
M3
Mark Mandell - Gone Round In New Jersey
The ads say "dirt won't stick to it" so a bit of overspray shouldn't be an issue. 
Closer, faster...
Jason Roehl in Lafayette, IN
Get the spray gun closer to the surface, move it faster, and use the lowest airflow/atomizing air pressure settings you can that will still adequately atomize the finish. Thicker finishes don't have to be blasted into microscopic droplets.
All these will drastically reduce overspray.
Jason
Better
Mark Mandell - Gone Round In New Jersey
This is where the quality of the gun really comes into play. I run a Walcom gun on a pot and a C-A Tech Jr. mini gun. Both will lay down clear finishes (solvent and WB) like glass with only 15 PSI on the gun gauge. Overspray is minimal and I'd estimate transfer efficiency at better than 75%.