Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

a warm water rinse for the washer

Posts

a warm water rinse for the washer

#1

a warm water rinse for the washer

Bill Tindall, E.Tn.



One of the many annoying intrusions of the government is the government's decision on how much water one can use to wash clothes as well as the elimination of the warm water rinse. Both can be thwarted. Speed queen enables the person washing to have control over the amount of water added. Addition of the device in the picture enables a warm water rinse. This valve arrangement is hooked up as follows. Hot water supply and hot water feed to washer is connected to one side of the valve and cold on the other. By adjusting the position of this valve and the cold water supply valve the temperature of the "cold" water delivered to the washer can be adjusted to any temperature up to that of the hot water.

Re: a warm water rinse for the washer

#2

Re: a warm water rinse for the washer

Yonak

Bill, what does a warm water rinse do that a cold water rinse does not ?

Re: a warm water rinse for the washer

#3

JL

Re: a warm water rinse for the washer

JL

I don't know about your area - but around here the cold water gets very cold in winter.

Warmer water solubilizes things much better. Mineral salts, dirt, calcium salts of fatty acids and other things are more soluble in warm water.

You don't think that a few degrees will make that much of a difference until you experiment.


Re: a warm water rinse for the washer

#4

answer

Bill Tindall, E.Tn.

pleases the wife who doesn't like to be told by the government that what she, and her mother before her, did to get clothes clean is no longer allowed.

I think I would like doing the laundry and did when I was single. But this is one function that appears to be stoutly defended from intrusion by me or the government.

Re: a warm water rinse for the washer

#5

Re: a warm water rinse for the washer

Bill Tindall, E.Tn.

Even here in TN our water runs in the low 40's in the winter. It makes your hands numb working in it. In any case one needs to be suspicious of some ruling designed to please the Greens in CA that alters what was done for a century before.

I do know that after using her sister's washer in CA wife searched for a while until she found a washer that worked more traditionally (and a lot faster). Thanks to someone on WC for the lead to success- Speed Queen.

Re: a warm water rinse for the washer

#6

You're Welcome

Dave's Not Here

I'm pretty sure I was that person. I know that I did recommend to someone that they look into the Speed Queen line awhile back, maybe a year or less, and they did purchase one.

Re: a warm water rinse for the washer

#7

Re: answer

Yonak

I have used cold water rinse for 30 years and even cold water wash with some loads, especially deep colors, and I've not noticed my clothes not being clean or rinsed well. Have you noticed clothes still dirty after being rinsed in cold water ?

Re: a warm water rinse for the washer

#8

an added bonus

Bill Tindall, E.Tn.

In addition to pleasing wife, never a flawed strategy, she has found that this modification enables her to control the temperature of the "warm water", as defined by the washer programming. We set our hot water heater at a fairly cool temperature for various practical reasons. Hence, in the winter when our cold water is near freezing the "warm" created by some pre-programed mixture of hot and cold supply at the washer winds up being anything but warm. Now she has control over this wash cycle temperature as well.

Re: a warm water rinse for the washer

#9

Re: an added bonus

paul in AZ

Modern soaps are designed to be used with cold water.

Seems more ideological than functional but if it pleases her what can you do?

Re: a warm water rinse for the washer

#10

Well Water Caution

Mark Mandell - Gone Round In New Jersey

If your water is not chlorinated, and especially if you have a well, lowering your water heater temperature will save you money but will expose you to a substantial health risk. The Legionnaire's Disease bacterium is actually pretty common in ground water and will flourish in a water heater set at or below 110° F. Showering provides for direct inhalation of the pathogen.

Luke-warm water will also render a dishwasher mostly useless.

Re: a warm water rinse for the washer

#11

detergent

Bill Tindall, E.Tn.

About 20 years ago detergent formulation likely got as good as it was going to get. This era Tide was, and likely still is, the product to strive to equal. Developments since then have been in response to cost, convenience and regulation, not better performance, but rather acceptable performance in the new regulatory, cost and convenience market. Formulation has met regulations, provided convenience, lowered raw material costs. It's a safe bet that anything labeled "for cold water" isn't a better detergent, overall, just better in cold water.

About 30 years ago in the every day products like chain saws and light bulbs, in response to regulation and cost, R&D effort switched from providing better quality and performance to meeting regulation and cutting manufacturing cost.

I worked for a while on detergent additives. We were working on a color- safe bleach additive for Europe, something similar in performance to the exceptional Tide additive of that day, but one that worked under European water temperature preferences. It worked great till it was discovered that it dissolved the washer hoses. Sounds like a repeat of the early ethanol in gas problems.

Re: a warm water rinse for the washer

#12

Those fittings make me think of something else

Howard in Toronto

Reminds me of relations between Toronto municipal politics and Ontario's provincial Liberals.

The Liberals are delirious Toronto's mayor has discredited himself so badly - it takes the heat off them for trying to "mate" with Ontario's population this past decade.

Re: a warm water rinse for the washer

#13

110????

John in NM

That's nuts, it's only tepid!

Wow... can't imagine setting the heater that low... :D

But then I'm pretty much behind the times on a lot of stuff :D

Re: a warm water rinse for the washer

#14

Cross Connect?

Tim Greif - West of Chicago

You've cross connected the hot and cold with no check valves. What prevents cold water from flowing into your hot water lines and vice versa?

Re: a warm water rinse for the washer

#15

Code

Mark Mandell - Gone Round In New Jersey

Plumber in my area (Joisey) will not install a heater set at more than 110°, and a building inspector will fail the heater for a higher setting. Rule is designed to prevent children and elders from scalding injuries. After they leave, I put it back to 140° where it "belongs!"

Re: a warm water rinse for the washer

#16

Nothing 


Re: a warm water rinse for the washer

#17

Re: Cross Connect?

del schisler

the water preasure is the same on both line's ? all you are doing is cutting down the flow of water for each line ? and drecting other water in the flo , it can't flow backward's ? it is the same preasure ? unless i am thinking wrong , been noted for that

Re: a warm water rinse for the washer

#18

Yeah...

John in NM

140 is definitely where it belongs. I don't remember the IRC covering water heater settings, but our local code more or less follows it closely. I don't recall anyone ever challenging the water heater settings when we built our house. Came from the factory set at 140 and I've never changed it :D

Re: a warm water rinse for the washer

#19

Sometimes systems are even designed to do that...

John in NM

So I'm not sure what the problem would be :D

Recirculating systems designed to prevent wasting gallons of water waiting for the hot to flow just put the cooled off hot water back into the cold line at the point of use. May not be up to code in all areas, but they seem to work fine where they are used.

Re: a warm water rinse for the washer

#20

Re: Cross Connect

Mark Mandell - Gone Round In New Jersey

Hot will flow into the cold line when a cold tap is opened elsewhere because the cold line will be marginally lower in pressure than the hot, so the piping will seek to equalize the pressure in both lines.

The valve pictured appears to have too many connections. A mixing valve needs two inlets but only one outlet. For the desired temperature, you'd need to split the hot water supply and use one branch to feed into a "Y" in the cold line with a simple ball valve upstream in the hot supply ahead of the wye.

You can solve any backfeed issue, which would be minimal at worst, by turning off the extra hot valve after each use.

Re: a warm water rinse for the washer

#21

Re: Cross Connect

Bill Tindall, E.Tn.

when the ball valve is closed the arrangement is identical to when this assembly was absent. That is why I chose a 1/4 turn ball valve. Easy to close. When open one gets warm water delivered to the "cold" inlet of the washer. All that part has been demonstrated.

However, closing the valve when not in use may not be a practical necessity. Have yet to demonstrate it to be so, or not. Trying to analyze the situation is boggling complex, but I think it is irrelevant except under situations where only cold is being drawn for an extended period somewhere else in the house. If a quart sloshes back and forth during a toilet flush on the occasion where wife forgets to close the value it is not economically meaningful to worry about.

Re: a warm water rinse for the washer

#22

Re: Cross Connect?

Ed Wozniak-Buffalo, NY

What keeps the hot water in a hot water tank from backflowing out the cold inlet of the hot water tank?

Re: a warm water rinse for the washer

#23

Jason Roehl in Lafayette, IN

Kinda funny, but...

Jason Roehl in Lafayette, IN

...two of the compounds represented in that graph have less solubility as the temperature of the water increases (one goes up exponentially until the freezing point, then drops slowly and linearly as temperature rises).

I would wonder what effect the warm water rinse would have on the dry time...(since a shorter dry time would reduce energy usage...)

Jason

Re: a warm water rinse for the washer

#24

Jason Roehl in Lafayette, IN

Re: Code

Jason Roehl in Lafayette, IN

6.5 years ago when we moved into this house, the inspector said that the current "wisdom" was below 120ºF for safety purposes. Since we had children ages 6-9 at the time, it seemed like a good idea. That lasted about a week at most. It's now set to at least 140ºF. You know, USEFUL hot water, and since we don't shower at that temperature, there's MORE hot water available when everybody's running through the shower in quick succession.

Jason

Re: a warm water rinse for the washer

#25

Jason Roehl in Lafayette, IN

You could...

Jason Roehl in Lafayette, IN

replace those two wyes with ones that have 1/4-turn ball valves on each output, thus manually preventing backflow. Or, I'm sure you could find a way to put a check valve on each inlet.

Jason