One of my favorite books, and one I highly recommend to woodworkers, is Understanding Wood: A Craftsman's Guide to Wood Technology by R Bruce Hoadley. Some of the topics are still a bit fuzzy for me even after several readings over several years. Can anyone recommend similar books, as sometines an alternative explanation is very helpful. Right now, my particular interest is heartwood versus sapwood, formation of heartwood, and related.
For technical data on wood- composition and structure, drying, structural properties, working properties, etc all 19 chapters- the USDA publication "The Encyclopedia of Wood" isbn 13:978-1-60239-057-7 is hard to beat. It is easy to find it used and it is cheap new.
I just got Chris Becksvoort's "With the Grain", and it looks good. First impression is that it's not a textbook, but gives lots of insight, including discussion of heartwood/sapwood for each of a set of typical woods we most use.
That's probably the best there is, unless you prefer exercising the other side of your brain, in which case I would recommend Eric Sloan's A Reverence for Wood. I am accustomed to picking up copies of this whenever I find them, so I always have a copy to give to someone who shows a fresh interest in working wood.
Along the lines of Bill's USDA recommendation, you should also check out the FPL's Wood Handbook - Wood as an Engineering Material, FPL-GTR-113. You can buy it on paper from Lee Valley, or download it for free from the Forest Products Lab.
Don, the sapwood into heartwood subject has been a subject of interest for me for quite a while also, and no, I've never quite found as much info as I would like about it. All of the books mentioned thus far, left me want to know more.
A friend loaned me a college text book on Physics of Wood.
Do you have a specific question that you are working on? It is not as simple as annual rings, where one ring is added each year. Sometimes there can be a significant jump. I have seen this in lots of the larger trees that I have dissected for the lathe and sawmill. One of the papers that I read speculated that this could be due to different changes of water pressure on certain years of good or suppressed growth. I don't think that is it myself. I think it has more to do with AIR exposure at the cambium.
A couple of old trees that come to mind were Walnut, and Post Oak, which had been hit by lightning 50 or more years earlier, where the bark had been blown off a strip about 3-4" wide. The tree healed over in a few years, and the wood grew normally after, but the bark was only half as thick.
I've noticed in Eastern Red Cedar, Juniperus virginiana, that behind every Yellow-bellied woodpecker peck, there is a white patch of sapwood which never makes it into heartwood. My theory here, is that when they leave here in the spring, the tree heals, but enough of the sap has polymerized in and around the pecks, which blocks the air exposure afterwards.
Yet on the same species, which around here seem to manage to keep a limb or two alive, long after most of the tree is dead, leaving only a strip of bark covering the living tissue on an otherwise dead tree. Here, I find that the air coming around the edge of the bark, turns each year into heartwood right up to the bark, for about the first half inch over.
I keep thinking I should do a simple test that I have in mind to prove this. I was thinking maybe I should cut out some message in bold letters, then go out to a tree somewhere that I intend to harvest in the future. After thinning the bark with a draw-knife bond the sheet-metal letters to the thinned bark with silicone, then when I go back to harvest the wood, I could saw out a board which could have "See, I Told You" naturally appearing in the wood. ha
Now that I have said it, I have to do it. Gotta go get myself back up to LR. My brother Wood Newton will be there playing his songs at the Arkansas Singer Songwriter Showcase, at the Main Library Darragh Center tonight. He is the talented one of our family.