Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Desk framing done....at last!

Posts

Desk framing done....at last!

#1

Desk framing done....at last!

Bill Tindall, E.Tn.


When I started this desk I thought it would be an easy build. The joinery turned out to be difficult due to a lot of joinery at the legs, the shaped legs and the curved stretcher. 44 parts and 48 joints in this part. The top was done months ago. The drawers will be routine. I think I will cock bead them with a black border.


This view has the desk upside down showing the hidden dovetails holding the stretchers. The straight stretcher has not been notched and seated yet.


It can be a bit tense chopping away on a largely completed desk to install the stretcher dovetail sockets. The male part of the dovetail is precisely fitted on the end of the stretcher, the stretcher clamped in place, and the profile of what ever dovetail shape I wound up with transferred to the receiving stretcher. I use a guide block to aid sawing the boundary of the dovetail socket and then the waste is chiseled away.

Re: Desk framing done....at last!

#2

Re: Desk framing done....at last!

roger lance

Bill....your work is becoming noticeably sophisticated....I think you've elevated the bar.

Re: Desk framing done....at last!

#3

Re: Desk framing done....at last!

Paul Leuba

Wonderful job on the joinery on the desk, Bill. In the last picture how were you able to saw only partially through the width of the receiving stretcher for the dovetail socket before chopping away the waste?

Paul in Hunt Valley, MD

Re: Desk framing done....at last!

#4

Re: Desk framing done....at last!

Bill Tindall, E.Tn.


This pictures shows sawing a dovetail socket for a drawer divider. I use a guide black and saw in as far as I can and down as far as I can. Sometimes I can use the end of this saw to partially make a "stopped " cut so as to deepen the saw cut some in the back. What can't be sawed gets chiseled. I almost always use a guide black for chiseling the angled side. I often free hand the straight side.

Re: Desk framing done....at last!

#5

Nice job Bill!