Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Help with table saw miters

Posts

Re: Help with table saw miters

#26

Here are my two favorites

John Lucas

I've made a lot of miter jigs over the years. Here's the two I use the most and have found the most accurate. The first is my jig for segmented work. It is micro adjustable. Once I've done the testing and sneak up on the perfect fit I measure between the brass pins with a vernier caliper (I have a really large set). That way the position is repeatable within a few thousandths. I did decide to start making marks on the outside recently so you'll see the 16 side indicator. It will be interesting to see how close I can get it without the calipers. Because length of cut is just as important as the angle I have a sliding stop block on the right that is adjustable. For the best accuracy I think a jig should slid in both miter slots.

The second one is my picture frame jig. I got this out of a magazine long ago and it works really well. I added the little block in the center. Don't remember now why I did that but it was important at the time. You cut the first miter in the top jig with the center block removed if necessary. Then you set the stop block on the lower jig and cut the second miters. I have different holes for the stop block so it can go out quite a ways or move down for really short sided frames. The runners for this one were made from a somewhat soft plastic and fit the slot perfectly so there isn't any movement of the sled. Not as accurate as the segmented sled but good enough for 4 sided miters.




Re: Help with table saw miters

#27

question

Bill Tindall, E.Tn.

The black knob....is this for fine adjustment?

Re: Help with table saw miters

#28

another question....

Bill Tindall, E.Tn.

How are the bolt heads captured such that they don't drag on the table yet allow the arm to swing easily?

Re: Help with table saw miters

#29

I like it

John in NM

Only change I would make is using some 80/20 extrusion for the arms and a Kreg jig stop (or something similar) for repeating lengths.

Re: Help with table saw miters

#30

the knob is for fine adjustment


Re: Help with table saw miters

#31

Re: another question....

John Lucas

I used carriage bolts that ride is a groove on the underside. One groove for the head and one slot for the square part of the carriage bolt. I do have to loosen it more than you would think to get it to slide easily for the course adjustment but I don't do that a lot so it's not a problem. Slight loosening works well for the fine adjustment.