Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

need dust collector help

Posts

need dust collector help

#1

need dust collector help

Earl

I am putting up my dust collection (long time coming). I want to have the collector come on when I open the gate. I am making my gates and need micro switches. Anybody know of a good source for reasonably priced switches? What kind to use? I am also using snap lock pipe. What is a good way to cut it? Thanks for any help. Earl

Re: need dust collector help

#3

Re: need dust collector help

Larry in NW Ohio

Earl There is a surplus place that I have dealt with over the years, and they have some cheap ones. They have them as cheap as $.69 w/ a long arm and it`s 5 amp. Go to www.surpluscenter.com You should have come here before you started to put your DC together, we may have talked you into using PVC piping. That`s much cheaper and easier to work with, but of course that is just my opinion. What kind of collector did you get. Good luck with getting it together. Larry

Re: need dust collector help

#4

Re: need dust collector help

Alan in Little Washington (NC)

The first question you need to answer is how will the DC be switched- no microswitch will handle the DC motor voltage and current. You will need to use a mag starter or contactor (a big relay) with a low voltage coil.

Once you answer that question then we can recommend a micro switch with the proper rating.

Re: need dust collector help

#5

Re: answer to some ?

Earl

I bought an Oneida 1 1/2hp cyclone from a guy that is getting ready to move. It came with almost all the pipe I needed but it is the snap lock. It also has the JDS dust gate controller (with the low voltage). Has some 4" gates but I want to use mostly 5&6" gates. Thanks John & Larry for the links I'll check those out. Thanks for all the replys. Earl

Re: need dust collector help

#6

Re: need dust collector help

Larry in nw ohio

Earl How much do you know about electrical to wire this together without being electricuted or burning something up. Be very careful or get a knowegable friend. Good Luck Larry

Re: need dust collector help

#7

Re: need dust collector help

Grant in Iowa

PVC is cheaper in 4" diameters, but once you get to six inches and higher, it becomes less compelling economically.

I ended up with 7" and 6" snap lock from Oneida. I wouldn't change a thing looking back. The 6" ducting has allowed me to move much more air than 4" could.

Everyone has different needs, budgets, spaces though so I won't be so arrogant as to say that what I did is right for everyone.