Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

Rub for TX smoked brisket..needed

Posts

Rub for TX smoked brisket..needed

#1

Rub for TX smoked brisket..needed

Bill Tindall, E.Tn.

Smoked a brisket today- 4 hr smoke, seal, 4 hr 225 F oven. Meat was fine except it needed some pizzazz which I believe is provided by rub.

During the last step, the oven, a cup of meat juice came out and was floating about in the aluminum foil sealed container. Normal, preventable? Would be better if it stayed in the meat.

Re: Rub for TX smoked brisket..needed

#2

Jason Roehl in Lafayette, IN

Re: Rub for TX smoked brisket..needed

Jason Roehl in Lafayette, IN

Well, water boils at 212ºF, so I try not to exceed that temperature when smoking. The one exception is ribs, which need to go into a higher temperature to render the fat.

I think brisket lends itself to savory flavors, if that helps. The last time I did one, I probably either pulled something off the web or did some seat-of-the-pants seasoning. I also like vinegar--helps break down the meat fibers in tough cuts (like brisket). I would add a few tablespoons to the foil before it goes in the oven.

Jason

Re: Rub for TX smoked brisket..needed

#4

Re: Rub for TX smoked brisket..needed

Robin Corell in Atascadero CA

You can sometimes get a lot of flavor by changing up the wood you use. Oak, hickory, and pecan all give a nice smoky flavor but they lack that pizazz you mentioned. Mesquite adds a ton of flavor and is well know for bbq and smoking but my favorite is olive wood, both of these will give you a bit of pizazz.

Robin

Re: Rub for TX smoked brisket..needed

#5

Re: Rub for TX smoked brisket..needed

Dean Johnson

http://www.thesmokering.com/forum/

All kinds of info on brisket and such....

Re: Rub for TX smoked brisket..needed

#6

Re: Rub for TX smoked brisket..needed

Derek Arita

Well...this is weird...a smoking question on a woodworking forum? Oh well...

Most experts say salt and pepper, 275* till internal reaches about 160*...foil with broth, then back in till internal reaches about 195* and start checking for probe tenderness...but I'm sure you know all that. I'm not a purist, so besides salt and pepper, I use some rib rub which is heavy on garlic, but again, experts say no sweet on brisket.