Re: How's the tension on the blade ? Supercut issu
Yonak
del, I honestly can't say for sure about the tension of the first blade but, on blades 2 through 5, I made certain the tension was correct according to the gauge on my Delta saw.
Knowledge You Can Build On — Est. 1998
Re: How's the tension on the blade ? Supercut issu
Yonak
del, I honestly can't say for sure about the tension of the first blade but, on blades 2 through 5, I made certain the tension was correct according to the gauge on my Delta saw.
Another welding shop ,just to check their weld job
del schisler
other than a tight turn, than must be a bad weld? Maybe you could under tighten ? the band just needs to be tighten enough so that it doesnt slip , if the spring is the orignal where you tighten than if it were me i would just under tighten, not to where the blade wonders in the cut, depends on how thick the wood is, If the spring has been replace with a new and stiff one it man not give as much as the old one did, my spring is the old one and seam's to work ok no curve or bowed cut. to bad their isn't a band place close by where you could have them reweld them ? than you could see if it is their weld job or not ? just talking here good luck