Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Tool gloat, not mine though.

Posts

Tool gloat, not mine though.

#1

Tool gloat, not mine though.

Keith Newton

I got a tip from a friend earlier this week, that there was an old industrial shop being sold off bit by bit, so we went over. My helper Ben found an old square back on the floor in a side room. Turns out it was a Starrett, which he got it for $1. It was the protractor type, and not in bad shape, just dirty. i had a few other stops to make before returning to the shop. By the time i got back he had it looking brand-new.

I managed to fill the bed of a pickup with assorted stuff like C-clamps, and cam-clamps for fixtures, some flexible blow-pipe, a 20# roll of tack-rag, a nice roll of graphite canvas, a really nice swivel stool. I may go back for another 4 drum filter system for the shop vacuum. There were two of these if anyone needs one.

There was a good looking 50 hp rotary vane air compressor sitting there looking tempting, but a lot larger than I need. Also a 3 head 42"Timesaver.

Re: Tool gloat, not mine though.

#2

Re: Tool gloat, not mine though.

Larry in nw ohio

Where is thid sale at? Also would it happen to be posted on the internet? Larry

Re: Tool gloat, not mine though.

#3

No listing, just some guy hanging out there.

Keith Newton

He worked in the shop when it was open, or so he says, but doesn't seem to know much.

He didn't strike me as being computer literate.

The location is Little Rock, AR.