Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Another Arborescent Table in progress *LINK*

Posts

Another Arborescent Table in progress *LINK*

#1

Another Arborescent Table in progress *LINK*

Keith Newton

I had a rough week last week. I cut about 1/2" off my right thumb, on the jointer. A lot of the wood on this project is figured maple, which has been a challenge to surface. I was getting a bit of tearout, even with a low cutting angle on the jointer, so I wet the face which solved that problem, but made feeding it over the jointer top harder.

I knew I should stop and wax the top, but only had two short boards to run, so proceeded. I always practice, and stress to others, to never feed in such a way, that if the wood were to disappear, that the effort of my hands would be into the cutter, and I was doing that then.

When I was feeding the wet wood, the traction made it hard to get a steady speed, so it was lurching along. As I neared the end of the board, I was just before reaching for the push-block, when it lunged forward about six inches, with my thumb overhanging the side of the 3/8" x 4" board, and into the blades.

Seven hours of time in ER, before I got into the operating room with a surgeon.

Last time I posted my signature / logo, David Barnett paid me a fine compliment. I posted a pic of the date that I had signed the table, and was wondering if I was going to be able to grip and manipulate that tool in the future. Right now, just holding a pencil between my middle and index fingers, looks more like scribbling, than writing.

A few words about the project. The little table will have a glass top, which will overhang the little branch ends by about 2" all around.

There will be a little desk lamp, which will give the main tree-trunk a suggestion of continuing on up above the glass top. Then the frame which Ben is holding over the backdrop paper, will have shoji paper between the two layers of grid. It will be about 15" above the desk, and is suggest upper branching of the tree. It is on a single track, and can slide to the right across in front of another set of open shelves, which are also joined in this reciprocal grid pattern, in the table top, and shoji.

All of the grid is joined with sliding dovetail joints. To keep this from being too easy, we decided to alter the lengths of each square in the grids, relative to its neighbors.


http://www.flickr.com/photos/7391658@N03/sets/72157631969142114/

Re: Another Arborescent Table in progress *LINK*

#2

Re: Another Arborescent Table in progress

Hank Knight

Keith,

Bummer about your thumb! I hope the injury doesn't permanently hamper your use of the hand. The problem with getting entangled with a jointer is that it doesn't leave anything to sew back on.

I'm intrigued with your table. Please post finished pics.

Hank

Re: Another Arborescent Table in progress *LINK*

#3

Re: Another Arborescent Table in progress

Robin Corell in Atascadero CA

Beautiful table. I have always liked nice clean design and you usually deliver just that. I also have an affinity for subtle curves and the subtle curves in the feet are exactly the perfect balance to angle of the "trunk" as well as repeating the curves in the support for the top.

Sorry to hear about your thumb. Injuries like yours are the ones that bother me the most. It’s easy to dismiss a careless mistake or one borne from poor safety practices, but when a lifelong craftsman with good safety practices get hurt it drives home the fact that it truly can happen to anyone.

Robin

Re: Another Arborescent Table in progress *LINK*

#4

Ellis Walentine

So sorry to hear

Ellis Walentine

... about your thumb, and what a tragic counterpoint it brings to your post of this magnificently creative piece of furniture. My first response is one of sympathy for your injury and loss, and then I want to praise the design and execution of these pieces, and for your stoicism in the face of this injury.

Mend well, and quickly.

Best regards,

Ellis

Re: Another Arborescent Table in progress *LINK*

#5

Alan Young

No Kidding-What Ellis said

Alan Young

I think the jointer scares me more than the TS- Having to put downward force towards the cutters in just plain nerve wracking. Sure hope the injury is not to debilitating.

Now then-What a great piece of work on that table-Love to see pictures when it has it's home...

-Alan

Re: Another Arborescent Table in progress *LINK*

#6

Re: Another Arborescent Table in progress

Larry Clinton At Frankfort, (Central) Indiana

Sorry to hear that, I tried to do a flatting on my left thumb on my planer about 5 years ago - didn't work too well. It was the first injury (and only) on equipment in over 20 years. I worked with industrial equipment until I retired with no injuries. Just took a moment of inattention & stupidity to really remove some flesh. I had just returned from an auction where I had purchased what appeared to be a full Cherry tree sawn into 4/4 boards, some 14~16 wide X 8' long. It had been dried in a old large building and was coated with dust - probably 15 - 20 years worth.

Anyhow, some did look like it was heavily figured and while the boys were stacking it upstairs in my shop, I took an odd cutoff piece and decided to run it across the joiner to see what it looked like. Tired and didn't have a pusher handy - piece was really to odd shaped to do it safely but I did it anyway, blade caught the piece and threw it, thumb came down on the blade. I didn't go to the doctor right away - just bandaged it myself but son and wife insisted so I went the next day. Dr. (GP) said a surgeon would graft, but he though it might grow over by itself in time, had me come back in a week or two and use a prescription antibiotic on the area. Took a few weeks - still serrated but works ok. Later did find the Cherry has a terrific figure. Still have the wood.

Re: Another Arborescent Table in progress *LINK*

#7

Re: Another Arborescent Table in progress

Thomas Skaggs, Foothills of Mount Level

Yikes!! I hope you heal well. For what it's worth, the table is super cool!!

Tom