Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Bar Stools ending

Posts

Bar Stools ending

#1

Bar Stools ending

larry in nw ohio

I`m getting to the end of the 3 bar stools I started about a year ago. I have them together and fit pretty good, and got the approval from my daughter and her husband. Now I`m going to take them apart to sand and do a few other miner miscalculations, like a couple of drilled hole that sort of gotten where they were not suppose to appear. I question, how would you finish it. It`s walnut and I would like the walnut color to show. Should I put some kind of sealer on first and then just put on a poly? Thank You Larry

Re: Bar Stools ending

#2

JL

Re: Bar Stools ending

JL

I dislike putting polyurethane only on chairs or stools. I usually go for polyurethane/BLO (or tung oil)/Mineral Spirits mixture 1:1:1.

I usually apply it "warmed". so it will penetrate a bit better - but you might thin it a bit more instead.

Re: Bar Stools ending

#3

just go with the poly..........

Dick Coers

no sealer necessary.

Re: Bar Stools ending

#4

Re: Bar Stools ending

larry in nw ohio

JL I always wondered what BLO was. But what does it stand for? Also mineral spirits is paint thinner, I`m just checking for sure. Thank You. Larry

Re: Bar Stools ending

#5

JL

Re: Bar Stools ending

JL

BLO is boiled linseed oil. I prefer using mineral spirits as it doesn't smell as much as paint thinner. It also is less of a mixture of things than paint thinner.